Items Relating To Editing (Nos. 301 To; Items Relating To Editing (Nos. 301 To - Sony SRW-5000 Operation Manual
Hd digital videocassette recorder format converter board digital betacam processor board rgb processor board
Hide thumbs
Also See for SRW-5000:
- Maintenance manual (438 pages) ,
- Operation manual (202 pages) ,
- Installation manual (54 pages)
Table of Contents
Menu List
Items Relating to Editing (Nos. 301 to ...)
Item number
Item
301
EDIT OPERATION
MODE
302
PREROLL TIME
POSTROLL TIME
303
304
VAR SPEED RANGE
FOR
SYNCHRONIZATION
305
EDIT FIELD select
306
SYNCHRONIZE
311
EDIT PRESET
REPLACE MODE
SELECT
A-24
Appendix
Function
Setting
CG
Selects the animation edit mode. For normal editing, use
[normal]
the "normal" setting.
CG: Primarily for recording computer graphics, this setting
allows editing by individual frames. When the edit is
completed, the OUT point automatically becomes the
next IN point. The next OUT point is automatically set
one frame ahead of the IN point.
normal: Use this setting for normal editing.
0 sec
This sets the preroll time. The range is from 0 to 30
. . .
seconds, in steps of 1 second. The preroll time should
[5 sec]
generally be set to at least 3 seconds, and for phase
. . .
adjustment with an editing controller it is recommended to
set the preroll time to at least 5 seconds.
30 sec
0 sec
This sets the tape running time after passing the OUT point
. . .
(postroll time) in automatic editing.
[2 sec]
The range is from 0 to 30 seconds, in steps of 1 second.
. . .
30 sec
[-1 to +2]
Specifies the variable tape speed range when the variable
speed playback is executed by a remote control unit
–1.15 to +2.45
connected to the REMOTE 1-IN (9P) connector.
–1 to +2: –1 to +2 times normal tape speed
–1.15 to +2.45: –1.15 to +2.45 times normal tape speed
Note
When an editing control unit such as BVE-9100 is
connected for DT editing, select "–1.15 to +2.45".
[1F]
Selects the start timing for editing when performing tape
2F
editing.
1F/2F
1F: Start editing from field 1 and end on field 2.
2F: Start editing from field 2 and end on field 1.
1F/2F: Following received timing commands.
Note
When the system frequency of this unit is PsF mode, the
unit always operates with the 1F setting.
[accurate]
When this unit is used as a controller for editing control of
another VTR connected through a 9-pin remote cable, this
rough
selects whether or not to carry out phase synchronization of
off
the two VTRs, and also the editing accuracy when carrying
out synchronization.
accurate: Editing is carried out with an accuracy of ±0
frames.
rough: Editing is carried out with an accuracy of ±1 frame.
off: Synchronization is not carried out.
[normal]
normal: Assigns edit preset command channels 1 to 8, to
track channels 1 to 8.
parallel
parallel: Assigns edit preset command channels 1 to 4, to
reverse
channel pairs 1/5 to 4/8.
stereo
reverse: Assigns edit preset command channels 1 to 4 to
channels 5 to 8, and channels 5 to 8 to channels 1 to 4.
stereo: Assigns edit preset command channels 1 to 4 to
track channel pairs 1/2 to 7/8.
(Continued)
Table of Contents
