1
Preparation
1. Remove the Dome Cover
a.
Gently turn the dome cover counter-
clockwise to unlock, then pull free of
the housing. If required, loosen the
security screw first.
b.
Gently pull the inner liner free of the
two notches in the housing.
Security
screw
c.
Set the dome and liner aside.
After
mounting and
adjusting the camera, attach the
dome cover:
a.
Attach the inner liner to the base until
the liner clicks into place.
b.
Align the dome cover with the three
dome tabs on the unit.
c.
Turn the dome gently clockwise until it
locks into place.
d.
If desired, secure the dome to the base
with the security screw (see picture).
2. Prepare the Mounting Surface (Surface or Flush Mount)
Use camera base or mounting
template to:
3. Connect the Wiring
24 VAC/12 VDC power connector
Video output connector
a.
Connect the video output
connector.
b.
Connect the 24 VAC/12 VDC power
connector.
2
Camera Mounting
4S Electrical Junction Box
Notch
Surface Mount
a.
Mark the holes as
required.
b.
Insert screw anchors into
holes.
Notch
Electrical box
a.
Secure the adapter plate to the
(not supplied)
electrical box using appropriate
screws (not supplied).
b.
If necessary, tuck Video/Power and
Adapter plate
BNC cabling into notch.
c.
Secure camera base to ceiling or wall
Screws
(not supplied)
with 3 screws, supplied.
Base
Screws
(supplied)
Flush Mount
Base
Notch
Skirt
Screws
(not supplied)
M3 screws
(not supplied)
Base
a.
Surface mount: Secure skirt to ceiling or wall
using appropriate screws, not supplied.
b.
If necessary, tuck Video/Power and BNC
cabling into notch.
c.
Surface mount: Secure camera base with M3
screws, supplied.
M3 screws
(supplied)
Flush mount: Secure camera base with
appropriate M3 screws, not supplied.
3
Camera Adjustment
B
C
A
Optional Camera Settings
Level
V-Phase
H
L
+
–
Focus lever
(top)
Adapter plate
Zoom lever
Setscrew
(bottom)
.
Picture Brightness
The LEVEL screw compensates for the iris level. L (low) darkens the
picture. H (high) brightens the picture.
Phase Adjustment
The V Phase Adjustment Pot adjusts the phase difference between
cameras. Switch 7 must be ON to activate Line lock (AC only).
DIP Switches
SW
High Res + TDN
(Refer to your
1
DC/AES
camera model)
2
AWB/ATW
3
BLC ON/OFF
Default settings are
4
AGC ON/OFF
shown in bold.
5
TDN
6
FLK ON/OFF
7
LL ON/OFF
8
Not used
Legend
A = Tilt rotation
B = Horizontal rotation*
C = Pan rotation
* If necessary, loosen the screw
that locks the gimbal assembly in
place, before adjusting the
camera.
Monitor out
Mode setting
DIP switches
1 2 3 4 5 6 7 8
= ON
= OFF
High Res
Std Res
DC/AES
DC/AES
AWB/ATW
AWB/ATW
BLC ON/OFF
BLC ON/OFF
AGC ON/OFF
AGC ON/OFF
Not used
FLK
FLK ON/OFF
LL ON/OFF
LL ON/OFF
Not available
Not used
Not available
