Table of Contents
Available languages
Available languages
492778-00 RP250 Router
ROUTER BITS (FIG. K) (NOT INCLUDED)
• Do not use router bits with a diameter greater than 1-1/8" (27mm). Use of larger than
recommended bits can result in a hazard.
Description
Straight bit (1)
Trimming bit (2)
Rabbiting bit (3)
V-grooving bit (4)
Core box bit (5)
Cove bit (6)
Ogee moulding bit (7)
Rounding over bit (8)
Dovetail bit (9)
Chamfer bit (10)
Troubleshooting
Problem
• Unit will not start.
For assistance with your product, visit our website www.black&decker.com for the
location of the service center nearest you or call the BLACK & DECKER help line at
1-800-544-6986.
MAINTENANCE
WARNING:
To prevent personal injury, always disconnect plug from power source
before performing any maintenance. Failure to do so could result in accidental
starting and possible injury.
• Regularly clean the ventilation slots in your tool using a soft brush or dry cloth.
• Regularly clean the motor housing using a damp cloth. Do not use any abrasive or solvent-
based cleaner.
IMPORTANT:
To assure product SAFETY and RELIABILITY, repairs, maintenance and adjustment
(other than those listed in this manual) should be performed by authorized service centers
or other qualified service personnel, always using identical replacement parts.
ACCESSORIES
Recommended accessories for use with your tool are available from your local dealer or
authorized service center. If you need assistance regarding accessories, please call:
1-800-54-HOW-TO (544-6986).
WARNING:
To reduce the risk of injury, do not use accessories rated below the
maximum speed on the rating plate of the tool.The use of any accessory not
recommended for use with this tool could be hazardous.
SERVICE INFORMATION
All Black & Decker Service Centers are staffed with trained personnel to provide
customers with efficient and reliable power tool service. Whether you need technical
advice, repair, or genuine factory replacement parts, contact the Black & Decker location
nearest you. To find your local service location, refer to the yellow page directory under
"Tools—Electric" or call: 1-800-544-6986 or visit www.blackanddecker.com
2/6/06
1:13 PM
Page 11
Application
Grooves and rabbets
Trimming laminates or hardwood; accurate profiling using a
template
Rabbets on straight or curved workpieces
Grooves, engraving and edge beveling
Fluting, engraving and decorative edge moulding
Decorative edge moulding
Decorative edge moulding
Rounding over edges
Dovetail joints
Chamfer edges
Possible Cause
• Cord not plugged in.
• Circuit fuse is blown.
• Circuit breaker is tripped.
• Cord or switch is damaged.
11
Possible Solution
• Plug in cord.
• Replace circuit
fuse.
• Reset circuit
breaker.
• Have cord or
switch replaced
at Black &Decker
Service Center or
Authorized
Servicer
- Quick Links:
- Operation
- Service Information
Hide quick links:
Table of Contents
