Basic hardware procedures
4.5
Reassembling
V
CAUTION!
Before attaching the covers, make sure no unnecessary parts or tools
●
are left inside the server.
In order to comply with applicable EMC regulations (regulations on
●
electromagnetic compatibility) and satisfy cooling requirements, the
server must not run while the top / side cover is removed.
For further safety information, please refer to chapter
●
information" on page
4.5.1
Installing the housing cover
Figure 7: Installing the housing cover
Ê Position the housing cover so that it protrudes somewhat over the rear edge
(1).
Make sure that each bolt is positioned in the corresponding nut.
Ê Push the housing cover as far as it will go in the direction of the arrow (2).
52
31.
Upgrade and Maintenance Manual
"Important
RX200 S8