Replacing The Sas Raid Hdd Module; Concluding Steps - Fujitsu PRIMERGY BX920 S3 Upgrade And Maintenance Manual
Server blade
Hide thumbs
Also See for PRIMERGY BX920 S3:
- Instruction manual (14 pages) ,
- Specifications (8 pages) ,
- Operating manual (66 pages)
Table of Contents
Expansion cards and backup units
7.2.4.3
Replacing the SAS RAID HDD module
I
The following procedure is identical for both variants of SAS RAID HDD
modules.
Ê Remove the defective SAS RAID HDD module as described in section
"Removing the SAS RAID HDD module" on page
Ê Install the new SAS RAID HDD module as described in section
the SAS RAID HDD module" on page
7.2.4.4
Concluding steps
Perform the following procedures to complete the task:
Ê Close the server blade as described in section
page
59.
Ê Reinstall and secure the server blade in the system unit as described in
section
"Installing the server blade in the system unit" on page
After installing or replacing an SAS RAID HDD module, update the firmware
Ê
as described in section
Ê In order to configure an SAS RAID HDD module that has been installed or
replaced, the module's Option ROM has to be enabled in the system board
BIOS. If applicable, proceed as described in section
scan" on page
Ê Enable boot watchdog functionality as described in section
watchdog functionality" on page
Ê If BitLocker functionality is used and has been disabled before starting the
maintenance task, re-enable BitLocker as described in section
BitLocker functionality" on page
Ê Please observe the notes on RAID rebuild in section
array rebuild" on page
152
"Updating mezzanine card firmware" on page
85".
89.
96.
97.
Upgrade and Maintenance Manual
147.
144.
"Closing the server blade" on
"Enabling Option ROM
"Performing a RAID
"Installing
60.
84".
"Enabling boot
"Enabling
BX920 S3
Table of Contents
