Related Manuals for Bosch TSplus/TS1
Summary of Contents for Bosch TSplus/TS1
- Page 1 Electric Drives Linear Motion and and Controls Hydraulics Pneumatics Service Assembly Technologies Publication Number: R980 500 366 7/09 TSplus/TS1 Modular Transfer Systems Belt Grinder Installation, Operation and Maintenance...
-
Page 2: Table Of Contents
The term “Original Purchaser”, as used All rights are held by ROBERT BOSCH GMBH and BOSCH REXROTH in this warranty, shall be deemed to mean the customer to whom the CORPORATION, also regarding patent claims. -
Page 3: Important Safety Information
Hanging hair repair work of any type on the conveyor can get caught in moving components Please contact Bosch Rexroth for copies system. Proper LOCK OUT procedures such as roller chain, drive belts, drive of the Material Safety Data Sheets (MSDS) -
Page 4: Introduction
Bosch Rexroth Corporation R980 500 366 07/09 Modular Transfer System Belt Grinder Introduction Prior to welding transport belts for TS1 or TSplus conveyors, the ends must be MOTOR tapered to provide the proper overlap. The MOVABLE ON/OFF belt grinder is designed to grind the belt... -
Page 5: Set-Up
R980 500 366 07/09 Bosch Rexroth Corporation Modular Transfer System Belt Grinder Set-Up Bevel Adjustment for 1.8mm thick TS1 or TSplus transport belt (Fig. 3) The belt grinder is preset with the “Marker Screws” in the 1.8mm location. This provides the correct bevel length for TS1 or TSplus conveyor transport belts. -
Page 6: Operation
Bosch Rexroth Corporation R980 500 366 07/09 Modular Transfer System Belt Grinder Operation The belt grinder will grind two belts at once, in a single pass. The correct bevel is LOCATE BELT ENDS absolutely critical when welding TS1 or EVEN WITH RAISED TSplus transport belts. - Page 7 R980 500 366 07/09 Bosch Rexroth Corporation Modular Transfer System Belt Grinder Operation Grinding the belts: 1. Once the belts have been properly positioned, push down on the clamping lever to lock them in place. Make sure the belts are held securely.
-
Page 8: Maintenance
Bosch Rexroth Corporation R980 500 366 07/09 Modular Transfer System Belt Grinder Maintenance Other than replacing the abrasive on the PRY UP CORNER OF grinding drum as needed, the belt grinder REMOVE OLD ABRASIVE COVER AND is maintenance-free. Following the check-...