Table of Contents
NOTE 2: If the coffee is delivered too fast and the cream is not
satisfactory, see the "Adjusting the coffee mill" section.
NOTE 3: Tips for a hotter coffee:
•
Proceed as described in the section "Changing and setting
menu parameters", "Rinse" function.
•
Unless preheated, do not use excessively thick cups as they
will absorb too much heat.
•
Preheat the cups by rinsing them with hot water.
NOTE 4: Coffee delivery can be interrupted at any moment by
re-pressing the previously selected icon which remains lit during
the operation.
NOTE 5: As soon as delivery is finished, to increase the quantity of
coffee in the cup, just keep pressing the previously selected icon
within 3 seconds after delivery has finished.
NOTE 6: When the appliance displays "FILL TANK", fill the tank
with water or the appliance will not deliver coffee.
(It is normal for there to be a little water left in the tank).
NOTE 7: After about 14 single (or 7 double) coffees, the appliance
displays " EMPTY WASTE COFFEE CONTAINER".
Even if not full, the empty waste coffee container message is di-
splayed 72 hours after the first coffee has been delivered. For the
72 hours to be calculated correctly, the machine must never be
turned off with the main switch in the 0 position.
To clean, open the service door on the front of the appliance
by pulling the spout (fig. 16), extract the drip tray (fig. 17) and
clean.
When cleaning, always extract the drip tray completely.
Important! When extracting the drip tray, the waste
coffee container MUST always be emptied.
If this is not done, the machine may be clogged.
NOTE 8: Never extract the water tank while the machine is de-
livering coffee.
If it is removed, it will not be possible to make the coffee and
the appliance will display "GROUND TOO FINE ADJUST MILL AND
PRESS OK" and then "FILL TANK". Check the level of water in the
tank and replace in the appliance.
To turn the appliance back on, insert the water spout if not al-
ready in place (fig. 6), then press the OK icon (B9). "HOT WATER
PRESS OK" is displayed.
Press the OK icon (B9) within a few seconds and deliver water
from the spout for about 30 seconds. When delivery stops, the
basic modes are displayed again.
N.B.: The coffee maker may request the operation to be
repeated a number of times until the air is completely elminated
from the hydraulic circuit.
N.B.: if this operation is not performed correctly or if the
machine is turned off, the basic modes may be displayed, althou-
gh the problem is in fact still present.
CHANGING THE QUANTITY OF COF-
FEE IN THE CUP
The appliance is set by default to automatically make the fol-
lowing types of coffee:
•
espresso
•
small cup
•
medium cup
•
large cup
•
mug
To change the quantity, proceed as follows:
•
Press the
icon (B2) to enter the menu (fig. 15). Press
the
icons (B7) and (B8) (fig. 2) until " PROGRAM COF-
FEE" is displayed.
•
Press the OK icon (B9).
•
Select the type of coffee you want to change by pressing
the
icons (B7) and (B8).
•
Press the OK icon (B9) to confirm the type of coffee you
want to make.
•
Use the
icons (B7) and (B8) to change the quantity
of coffee. The progress bar shows the quantity of coffee se-
lected.
•
Press the OK icon (B9) again to confirm (or the icon (B6) to
cancel the operation).
•
Press the
(B6) icon (B6) (fig. 18) twice to exit the
menu.
The appliance is now reprogrammed with the new settings and
is ready.
13
EN
Hide quick links:
Table of Contents
Troubleshooting
