Figure 58 Identify Device Information - Hitachi HTS541616J9AT00 - Travelstar 160 GB Hard Drive Specifications
2.5 inch ata/ide hard disk drive
Hide thumbs
Also See for HTS541616J9AT00 - Travelstar 160 GB Hard Drive:
- Install manual (2 pages) ,
- Datasheet (2 pages)
Table of Contents
93
xxxxH
94
80xxH
95
0000H
96
0000H
97
0000H
98-99
0000H
100-103
Note.2
104
0000H
105-106
0000H
107
8848H
108-111
XXXX
Note.1 The '*' mark in 'Content' field indicates the use of those parameters that are vendor specific.
Note.2 See following table 'Number of cylinders/heads/sectors by models for Number of cylinders/heads/sectors by
models for HTS5416XXJ9AT00'.
Figure 58 Identify device information --- Continued ---
Travelstar 5K160 (PATA) Hard Disk Drive Specification
Hardware reset result
15-13 Device detected result
15 (=0) Reserved
14 (=1) Always
13 (=x) 1=Device detected CBLID- above V
12-8 Device 1 hardware reset result.
Device 0 clear these bits to 0.
12 (=0) Reserved
11 (=x) 1=Device 1 passed diagnostic
10-9 (=x) how Device 1 determined the device number:
8 (=1) Always
7-0 Device 0 hardware reset result
Device 1 clear these bits to 0.
7 (=0) Reserved
6 (=x) 1=Semi-duplex mode is enabled
5 (=x) 1=Device 0 detected Device 1
4 (=x) 1=Device 1 passed diagnostic
3 (=x) 1=Device 0 passed diagnostic
2-1 (=x) how Device 0 determined the device number:
0 (=1) Always
Automatic Acoustic Management value
Stream Minimum Request Size
Streaming Transfer Time – DMA
Streaming Access Latency – DMA and PIO
Streaming Performance Granularity
Maximum user LBA address for 48-bit Address feature set
Streaming Transfer Time - PIO
Reserved
Inter seek delay time (1.5tt + 2.5tl)
World Wide Name
110 / 188
0=Device detected CBLID- below V
00=Reserved
01=a jumper was used
10=the CSEL signal was used
11=some other method was used or the method is
unknown
00=Reserved
01=a jumper was used
10=the CSEL signal was used
11=some other method was used or the method is
unknown
15-8 Vendor's Recommended Acoustic Management level
7-0 Current Automatic Acoustic Management value
Default value is FEh
iH
iL
Hide quick links:
Table of Contents
