Low Battery Indication
When the unit goes into a Low Battery condition, the yellow LED will not flash when a button is pressed. Change both batteries immediately.
To Replace the Batteries
1.
Remove the screw from the back case.
2.
Remove case back by using the blade of a small screwdriver to pry open.
3.
Place batteries as shown on diagram. Use CR2430 or DL2430Lithium batteries only.
4.
Close the case by snapping case front and back together.
5.
Replace the screw to secure the case.
Improperly installing the batteries will cause damage
to the batteries.
WARNING!
Removing or Inserting the Unit from a Belt Clip
Signals sent by wireless transmitters may be blocked or reflected by metal objects before they reach the alarm receiver. Even if the
signal path has been recently checked during a weekly test, blockage can occur if a metal object somehow blocks the signal path.
Wireless button type transmitters that have visual and audible indications of status must be used to confirm that the desired action
(such as arming) has occurred after pressing a function button on any of these transmitters. Be sure to listen for appropriate
audible and visual indications that such action has occurred. Otherwise, you could inadvertently leave yourself or your premises
unprotected.
External factors such as humidity, high or low temperatures, or constant activation of a programmed button may reduce battery life
in a given installation. If the button unit is used infrequently, activate it regularly (once per week) to confirm operation. A button
type transmitter will report a low battery condition to the alarm control when a low battery status is detected.
ÊK3636V3fŠ
K3636V3 9/04 Rev. A
LIMITATIONS STATEMENT
165 Eileen Way, Syosset, New York 11791
Copyright © 2004 Honeywell International Inc.
www.honeywell.com/security
