Use Active Configuration Mondebug_Internal - Fujitsu MB88121 SERIES User Manual

7) Select Active Configuration "MONDEBUG"

With this selection the project is linked to be used with the Softune Workbench monitor

debugger. Corresponding linker settings are done for the memory map in order to avoid

overwriting of the sections which are used by the monitor debugger. The code is linked in

this configuration for external SRAM, otherwise it is not possible to debug code with the

Softune Workbench monitor debugger. The monitor

7. Check MCU settings in the module start91460.asm. Be careful regarding any

modifications. If the peripheral clock speed is modified it can happen that the

communication between Softune Workbench and monitor debugger is lost. In the

module start91460.asm some basic MCU settings are done and some initial data

copy transfers are performed for specific data sections e.g. INIT. Check module

vectors.c if any interrupts are used for proper vector table set-up.

8. Write application code in the module main.c or add any other module to the project.

9. Write and modify source code and settings corresponding to the needs of the

application. Finally use "Make", or "Build" to compile and link the project. The

generated output files can be found in the sub-folder MONDEB_INTERNAL of the

project folder. The *.mhx file (Motorola S-Record) is located in the ABS sub-folder.

© Fujitsu Microelectronics Europe GmbH

SK-91F467-FLEXRAY V1.1

Getting Started

Figure 5-3: Project configuration selection

Note:

Always check the memory map of the linker settings and ensure

that this memory map is suitable for the application and target

system in use. Additionally the .mp1 file should be checked to

ensure correct settings.

- 49 -

FMEMCU-UG-910017-11