Table of Contents
3.2 FlexRay CC Operating-Mode (S2)
The DIP-switch S2 is used to set the operating mode of the FlexRay communication
controller. Ensure that the mode pin settings correspond to the operation-mode of the
application. For more detailed information please check the Hardware-Manual of the
FlexRay CC.
DIP switch
S2/1 (MD0)
S2/2 (MD1)
S2/3 (MD2)
S2/4 (MDE0)
S2/5 (MDE1)
S2/6 (MDE2)
Default: grey
Table 3-2: FlexRay CC Operating Mode
By default, the "16-bit non multiplexed mode" is selected.
Dip-Switch S2
(default setting)
Figure 3-2: FlexRay CC Mode Switch
FMEMCU-UG-910017-11
SK-91F467-FLEXRAY V1.1
Jumpers and Switches
Setting
ON (closed)
OFF (open)
ON (closed)
OFF (open)
ON (closed)
OFF (open)
ON (closed)
OFF (open)
ON (closed)
OFF (open)
ON (closed)
OFF (open)
MD0
MD1
MD2
MDE0 MDE1 MDE2
1
2
3
4
5
- 20 -
Logical value
0 (low)
1 (high)
0 (low)
1 (high)
0 (low)
1 (high)
0 (low)
1 (high)
0 (low)
1 (high)
0 (low)
1 (high)
Note:
ON
The DIP-switch (S2)
OFF
on PCB rotated 180°
6
© Fujitsu Microelectronics Europe GmbH
Table of Contents
