Replacing The Top Cover; Removing And Replacing A Side Cover; Side Cover Locations - HP rp7440 Service Manual
User service guide, fourth edition - hp integrity rx7640 and hp 9000 rp7440 servers
Hide thumbs
Also See for rp7440:
- Installation manual (73 pages) ,
- Administrator's manual (266 pages) ,
- Manual (114 pages)
Table of Contents
1.
Connect to ground with a wrist strap and grounding mat. Refer to
" (page 142)
2.
Loosen the retaining screws securing the cover to the rear of the chassis.
3.
Slide the cover toward the rear of the chassis.
4.
Lift the cover up and away from the chassis.
Replacing the Top Cover
1.
Orient the cover on the top of the chassis.
NOTE:
2.
Slide the cover into position using a slow firm pressure to properly seat the cover.
3.
Tighten the retaining screws to secure the cover to the chassis.
Removing and Replacing a Side Cover
It is necessary to remove and replace one or both of the side covers to access the components
within the server chassis.
Figure 6-3 Side Cover Locations
for more information.
Carefully seat the cover to avoid damage to the intrusion switch.
"Electrostatic Discharge
Removing and Replacing a Side Cover
145
- Quick Links:
- Cell Board
- Replaceable Parts
Hide quick links:
Table of Contents
Troubleshooting
