Table of Contents
PowerVault 130T Service Manual
TIP 0000: START
The Start TIP is the beginning point for all of the following PowerVault 130T Library TIPs. Whenever
a problem occurs and no FSC is displayed, begin the trouble isolation process here to help isolate and
fix the problem.
Problem
A failure has been detected, or is
suspected with the library or tape
drives.
1. Do you have a power problem?
2. Do you have a problem with the
operator panel?
3. Do you have a problem where the
operating system cannot access
the library or tape drives?
4. If you are uncertain, run
diagnostic tests on the library and
the drives.
4473D
Conditions That Could Cause This Problem
Power problems are detected in some part of the
library.
There is no display on the operator panel.
The operating system does not recognize the library
or tape drives.
The customer has observed an abnormal condition
with the library or tape drive.
Yes: Go to TIP 1000
No: Go to Step 2.
Yes: Go to TIP 2000
No: Go to Step 3.
Yes: Go to TIP 3000
No: Go to Step 4.
Refer to Chapter 2, TIPs, Diagnostics, and Procedures
for more information about running diagnostic tests.
TIP 0000: START
2–3
Table of Contents
