Checking, Changing and Installing
New Batteries
Your new safe arrived with 4-AA batteries pre-installed at the factory. It is important
to periodically check the batteries and, if necessary, replace with a new set.
Checking Batteries
1.
Locate the B key on the keypad and press.
2.
If the yellow LED flashes and you hear a beep, the batteries
are good.
3.
If the red LED flashes, change the batteries within two
months.
4.
If the LED does not light, then you must replace the
batteries immediately.
5.
Proceed to Changing and Installing New Batteries.
Changing and Installing New Batteries
Important:
Replacing the batteries will not erase your personal Passcode from memory. However,
weak or dead batteries will prevent the use of the digital key pad. Access to the safe
will have to be made using the Emergency Override Key.
1.
Using your personal Passcode or Emergency Override
Key, open the safe door and locate the battery
compartment on the back of the door.
2.
Press firmly in on the right side of the battery compartment
cover and slide to the left to open.
3.
Remove the 4 old batteries and replace with 4 new
Alkaline "AA" batteries. Make sure that they are installed
in the proper direction as illustrated on the battery
compartment interior.
4.
Replace the cover and, prior to closing, test your
Passcode as instructed
NOTE: Proper disposal of discharged batteries is encouraged!
8
on page 6.
(See page 7).
Battery
Cover
Red
Yellow
Light
Light
Hide quick links:
