Link Aggregation Control Protocol Configuration; Lacp Port Configuration - HP 438031-B21 - 1:10Gb Ethernet BL-c Switch Command Reference Manual
Hp 1:10gb ethernet bl-c switch for c-class bladesystem command reference guide
Hide thumbs
Also See for 438031-B21 - 1:10Gb Ethernet BL-c Switch:
- Reference manual (252 pages) ,
- Application manual (195 pages) ,
- Cli reference manual (190 pages)
Table of Contents
Link Aggregation Control Protocol configuration
Command: /cfg/l2/lacp
[LACP Menu]
The following table describes the LACP Configuration Menu options.
LACP Configuration Menu options
Table 118
Command
sysprio <1-65535>
timeout short|long
port
cur
LACP Port configuration
Command: /cfg/l2/lacp/port
[LACP Port 2 Menu]
The following table describes the LACP Port Configuration Menu options.
LACP Port Configuration Menu options
Table 119
Command
mode off|active|passive
prio <1-65535>
adminkey <1-65535>
sysprio
- Set LACP system priority
timeout
- Set LACP system timeout scale for timing out partner info
port
- LACP port Menu
cur
- Display current LACP configuration
Description
Defines the priority value (1 through 65535) for the switch. Lower numbers
provide higher priority. The default value is 32768.
Defines the timeout period before invalidating LACP data from a remote partner.
Choose short (3 seconds) or long (90 seconds). The default value is long.
NOTE:
processing. If your switch's CPU utilization rate remains at 100% for periods of
90 seconds or more, consider using static trunks instead of LACP.
Displays the LACP Port menu.
Display current LACP configuration.
mode
- Set LACP mode
prio
- Set LACP port priority
adminkey - Set LACP port admin key
cur
- Display current LACP port configuration
Description
Set the LACP mode for this port, as follows:
off—Turn LACP off for this port. You can use this port to manually configure
a static trunk. The default value is off.
active—Turn LACP on and set this port to active. Active ports initiate
LACPDUs.
passive—Turn LACP on and set this port to passive. Passive ports do not
initiate LACPDUs, but respond to LACPDUs from active ports.
Sets the priority value for the selected port. Lower numbers provide higher
priority. The default is 128.
Set the admin key for this port. Only ports with the same admin key and oper
key (operational state generated internally) can form a LACP trunk group.
HP recommends that you use a timeout value of long, to reduce LACPDU
Configuration Menu
144
- Quick Links:
- Establishing a Console Connection
Hide quick links:
Table of Contents
