Preparing To Connect The Water; Attaching The Edge Protection - Bosch B36ET71SNS - 36" Built in Bottom-Free Installation Instructions Manual
Installation instructions
Hide thumbs
Also See for B36ET71SNS - 36" Built in Bottom-Free:
- Brochure (138 pages) ,
- Use & care manual (88 pages)
Table of Contents
Available languages
Available languages
Select screws according to the thickness of the wooden
beam: length = min. 2.5 x beam thickness, diameter #12
or #14.
NOTE
Specify the number of screws according to the cavity
width, thereby ensuring that the beam can be atta-
ched securely.
According to the subsurface:
Locate wall studs near the rear panel of the cavity and
mark drill holes in the beam
or
Fasten suitable dowel into the rear wall.
Predrill the wooden beam.
Attach the wooden beam to the rear panel of the cavity.
7.
Preparing to connect the water
(only for appliances which require a water connection)
CAUTION
Turn off the main water tap to prevent damage caused
by leaking water.
Attach the connecting pipe to the shut-off valve
according to the instructions supplied by the
manufacturer of the ice maker installation kit.
Install the connecting pipe. Always observe the
indicated gap dimensions to prevent damage to the
connecting pipe when pushing in the appliance.
Attach the connecting pipe to the floor with adhesive
tape.
16
8.
Attaching the edge protection
To protect the corners of the installation cavity, attach
the supplied protective brackets with adhesive tape.
Chapters
Table of Contents
