Bosch SHE4AM02UC - Ascenta Dishwasher With 4 Wash Cycles Get Started

GETTING STARTED WITH YOUR NEW DISHWASHER

STEP 1 - AddInG rInse AGenT

FOR PROPER DRYING ALWAYS USE RINSE AGENT

detergent

rinse Agent

Compartment

Compartment

STEP 2 - AddInG deTerGenT

Opening the cover

•

Push dark gray button

STEP 3 - To sTArT THe dIsHwAsHer

Exposed Front Controls

1) Close the door

2) Turn on

3) Select a cycle

*If unit does not fill with water, ensure that incoming water supply is operational.

STEP 4 - wHen THe CyCle Is CoMPleTe

When is the Cycle Complete?

Depending on model you can tell when your unit has completed the cycle in one of the following ways. Please refer to your use and Care manual for

complete details.

• Countdown display at < 0 >

• Cycle completion signal sounds (tone adjustable)

Note that on most models you must turn the unit off (and then on again) before you can begin a new cycle.

Canceling a cycle

To cancel or change a cycle on hidden top control models, open the dishwasher

door far enough to expose the control buttons. Press and hold "start" button for

three seconds until "active" light stops flashing. Close the door and wait until

the dishwasher completes the cycle (approximately 1 minute). Open the door

and press the ON/OFF button. You may now begin a new cycle. For exposed

front control models, Press and hold "start" button for three seconds. Wait until

the dishwasher completes the cycle (approximately 1 minute). Open the door

and press the ON/OFF button. You may now begin a new cycle. Beware of hot

water splash-out.

Run Time

To save energy, this dishwasher has a Smart Control that automatically

adjusts the cycle based on soil loads and incoming water temperature. The

Smart Control makes decisions that can cause the cycle time and water

usage to adjust intermittently, and suddenly change mid-cycle. The cycle

times listed in the Use and Care manual are based on normal soil loads and

120°F incoming water and will vary based on your actual conditions.

AlwAys reAd your use And CAre MAnuAl For deTAIled InsTruCTIons And IMPorTAnT sAFeTy noTICes.

even if your detergent already contains it.

•

use fresh powdered detergent

for best results

3 TBS MAX

•

2 TBS (25 ML)

1 tablespoon will clean most

1 TBS (15 ML)

loads

•

3 tablespoons Max, do not

overfill

•

W hen using detergent tabs, lay

them flat to avoid contact with

the cover

Add detergent

4) Press start

•

Add rinse Agent when

the light on the control

panel illuminates

•

Lift tab to open

2) Turn on

• Clean light illuminates

• Cycle indicator light that shines on floor goes out

To contact customer service

open dishwasher door to

locate the label on right side.

There you will find:

Program progress and rinsing sounds

Cleaning/Final Rinse

Alternating sounds

Start

•

Closing the cover

•

•

Push rear of cover down

slide closed

firmly until you hear the

Hidden Top Controls

1) Open the door

4) Press start

3) Select a cycle

• Model Number

• Serial Number (FD#########)

• Toll Free Customer Service Phone Number

No sounds

9000266264 Rev. C• 12/07

To add rinse Agent

pour

in the oval

ClICK

5) Close the

door to start

Dry

End