Configure Open Systems Management Server; Configure Snmp Dialog Box - HP 316095-B21 - StorageWorks Edge Switch 2/24 User Manual
Edge switch 2/24 product manager user guide
Hide thumbs
Also See for 316095-B21 - StorageWorks Edge Switch 2/24:
- Service manual (322 pages) ,
- User manual (300 pages) ,
- Reference manual (214 pages)
Table of Contents
Configuring the Switch
3. Click a field in the Community Name column to select the row. Enter the SNMP
community name for the trap recipient. Enter up to 32 characters. This also
defines community names from which SNMP managers can read MIB variables
from or write MIB variables to the switch. Refer to the note under
SNMP on page 3-12
4. Click the Write Authorization check box to enable write authorization for the
community name. A check mark displays in the box to indicate that write
authorization is enabled.
5. Enter the IP address for a trap recipient (SNMP management station) by clicking
in the Trap Recipient column and entering an IP address.
NOTE: Step
6
skip to step 7.
6. Enter user datagram protocol (UDP) port numbers in the UDP Port Number
column. You can override the default UDP port number of 162 with any legal
UDP port number (1 to 65535).
Figure 3–6: Configure SNMP dialog box
7. Click Activate to activate the data and close the dialog box.
The SNMP configuration is stored in NV-RAM on the switch.
8. If you are finished configuring the switch, back up the configuration data. For
more information, refer to
Configure Open Systems Management Server
Use these procedures to configure the open systems inband management program to
function with the switch.
NOTE: The optional Open Systems Management Server feature must be enabled in order to
perform this procedure.
3–14
for more information about assigning community names.
usually is not necessary. If you do not wish to override the default UDP number,
Backup and Restore Configuration on page
edge switch 2/24 product manager user guide
Configure
5–6.
Table of Contents
