Settings On The Ethernet Hardware Page - Cisco AIR-LAP1252AG-A-K9 - Aironet 1252AG - Wireless Access Point Software Configuration Manual
Software configuration guide
Hide thumbs
Also See for AIR-LAP1252AG-A-K9 - Aironet 1252AG - Wireless Access Point:
- Datasheet (14 pages)
Table of Contents
Ethernet Configuration
Settings on the Ethernet Hardware Page
Speed
Cisco Aironet 1200 Series Access Point Software Configuration Guide
3-44
Figure 3-17 The Ethernet Hardware Page
Follow this link path to reach the Ethernet Hardware page:
On the Summary Status page, click Setup.
1.
On the Setup page, click Hardware in the Ethernet row under Network Ports.
2.
The Ethernet Hardware page contains one setting:
The Speed drop-down menu lists five options for the type of connector,
connection speed, and duplex setting used by the port. The option you select must
match the actual connector type, speed, and duplex settings used to link the port
with the wired network.
The default setting, Auto, is best for most networks because the best connection
speed and duplex setting are automatically negotiated between the wired LAN and
the access point. If you use a setting other than Auto, make sure the hub, switch,
or router to which the access point is connected supports your selection.
•
Auto—This is the default and the recommended setting. The connection
speed and duplex setting are automatically negotiated between the access
point and the hub, switch, or router to which the access point is connected.
Chapter 3
Configuration
OL-2159-03
Hide quick links:
Table of Contents
