Resetting The Configuration - Cisco AIR-LAP1252AG-A-K9 - Aironet 1252AG - Wireless Access Point Software Configuration Manual
Software configuration guide
Hide thumbs
Also See for AIR-LAP1252AG-A-K9 - Aironet 1252AG - Wireless Access Point:
- Datasheet (14 pages)
Table of Contents
Downloading, Uploading, and Resetting the Configuration
Resetting the Configuration
Note
Step 1
Cisco Aironet 1200 Series Access Point Software Configuration Guide
6-16
[IP address].ini
b.
[boot file from DHCP/BOOTP server].ini
c.
[boot file from DHCP/BOOTP server].ini by TFTP
d.
You can reset the access point configuration to the default settings without
resetting the access point's IP identity, or you can reset the configuration to the
default settings including the IP identity. If you reset the access point's IP identity,
however, you might lose your browser connection to the access point.
Two buttons on the System Configuration Setup page reset the configuration to
defaults:
Reset System Factory Defaults Except IP Identity—this button returns all
•
access point settings to their factory defaults except:
The access point's IP address, subnet mask, default gateway, and boot
–
protocol
The users in the User Manager list
–
The SNMP Administrator Community name
–
Reset All System Factory Defaults—this button returns all access point
•
settings to their factory defaults except:
–
The users in the User Manager list
The SNMP Administrator Community name
–
To completely reset all access point settings to defaults, follow the steps in the
"Resetting to the Default Configuration" section on page
Follow these steps to reset the configuration to default settings:
Follow the link path to reach the System Configuration Setup page.
shows the System Configuration Setup page. The link path is listed under Figure
5-9.
Chapter 6
Managing Firmware and Configurations
9-43.
Figure 6-9
OL-2159-03
Hide quick links:
Table of Contents
