Selecting Pages And Settings; Applying Changes To The Configuration; Using A Telnet Session - Cisco AIR-LAP1252AG-A-K9 - Aironet 1252AG - Wireless Access Point Software Configuration Manual
Software configuration guide
Hide thumbs
Also See for AIR-LAP1252AG-A-K9 - Aironet 1252AG - Wireless Access Point:
- Datasheet (14 pages)
Table of Contents
Chapter 2
Using the Management Interfaces
Selecting Pages and Settings
Applying Changes to the Configuration
Using a Telnet Session
Step 1
Step 2
Step 3
OL-2159-03
When you type names and settings that appear in brackets you jump to that page
or setting. HyperTerminal jumps to the page or setting as soon as it recognizes a
unique name, so you only need to type the first few characters in the page or
setting name. To jump from the home page to the Setup page, for example, you
only need to type se.
The CLI's auto-apply feature is on by default, so changes you make to any page
are applied automatically when you move to another management page. To apply
changes and stay on the current page, type apply and press Enter.
Follow these steps to browse to the CLI pages with Telnet:
On your computer's Start menu, select Programs > Accessories > Telnet.
If Telnet is not listed in your Accessories menu, select Start > Run, type Telnet
in the entry field, and press Enter.
When the Telnet window appears, click Connect and select Remote System.
In Windows 2000, the Telnet window does not contain pull-down menus.
Note
To start the Telnet session in Windows 2000, type open followed by the
access point's IP address.
In the Host Name field, type the access point's IP address and click Connect.
Cisco Aironet 1200 Series Access Point Software Configuration Guide
Using the Command-Line Interface
2-9
Hide quick links:
Table of Contents
