Frame Collection; Reset To Default; Port Disable; Port Enable - Dell PowerVault 50F Installation And Troubleshooting Manual
Dell powervault 56f 16-port fibre channel switch installation and troubleshooting guide
Hide thumbs
Also See for PowerVault 50F:
- Installation and troubleshooting manual (156 pages) ,
- User manual (42 pages) ,
- Rack installation manual (28 pages)
Table of Contents
Pressing while Frame Collection is selected displays a frame collection
method.
This command specifies two frame collection methods, bundle and piling. Using bun-
dling, frames are separated in different queues based on source/destination pairs.
Using piling, frames are accumulated per destination AL_PA if NL_Ports can handle
multiple frames in a loop. Additionally, piling can minimize loop traffic by reducing
overhead and increases the loop efficiency.
To set, press for Bundle or for Piling.
%
#
+
Pressing while Reset to Default is selected displays a Y es or No.
Clicking Y es and then pressing causes all values in the Configuration Menu to
reset to default conditions. Once the Ethernet IP address and the switchname are
changed, they are not reset to default values.
NOTE: Resetting the switch to default causes all configuration settings, names, and
passwords entered to be reset to default settings.
#
Pressing while the Port Disable message is selected displays a submenu to
select the port to disable.
Pressing while a selected port is displayed disables the port. The LED associ-
ated with the port changes from green to amber indicating the selected port has been
disabled.
Pressing while the Port Enable message is displayed opens a submenu
where you select the port.
Pressing while the selected port is displayed disables the port. The LED
associated with the port changes from green to amber indicating the selected port
has been enabled. When FL_Ports are enabled, the port initializes the loop attempting
to be the master.
&
Pressing while the Close Telnet Session message is displayed causes the
Telnet session to close immediately.
%
Pressing while the Reboot message is displayed causes the switch to
reboot immediately.
support.dell.com
Managing the PowerVault 56F 16-Port Fibre Channel Switch
3-13
Table of Contents
