Lacp Port Configuration; Vlan Configuration - HP GbE2c - Blc Layer 2/3 Fiber SFP Option Command Reference Manual
Hp gbe2c ethernet blade switch for c-class bladesystem command reference guide
Hide thumbs
Also See for GbE2c - Blc Layer 2/3 Fiber SFP Option:
- Interface manual (209 pages) ,
- Application manual (165 pages) ,
- Cli reference manual (153 pages)
Table of Contents
The following table describes the LACP Configuration Menu options.
Table 118
LACP Configuration Menu options
Command
sysprio <1-65535>
timeout short|long
port
cur
LACP Port configuration
Command: /cfg/l2/lacp/port
[LACP Port 2 Menu]
mode
prio
adminkey - Set LACP port admin key
cur
The following table describes the LACP Port Configuration Menu options.
Table 119
LACP Port Configuration Menu options
Command
mode off|active|passive
prio <1-65535>
adminkey <1-65535>
cur
VLAN configuration
Command: /cfg/l2/vlan <1-4095>
[VLAN 1 Menu]
- Set LACP mode
- Set LACP port priority
- Display current LACP port configuration
Description
Set the LACP mode for this port, as follows:
Sets the priority value for the selected port. Lower numbers provide higher
priority. Default is 128.
Set the admin key for this port. Only ports with the same admin key and oper
key (operational state generated internally) can form a LACP trunk group.
Displays the current LACP configuration for this port.
name
- Set VLAN name
stg
- Assign VLAN to a Spanning Tree Group
add
- Add port to VLAN
rem
- Remove port from VLAN
def
- Define VLAN as list of ports
ena
- Enable VLAN
dis
- Disable VLAN
del
- Delete VLAN
cur
- Display current VLAN configuration
Description
Defines the priority value (1 through 65535) for the switch. Lower
numbers provide higher priority. The default value is 32768.
Defines the timeout period before invalidating LACP data from a remote
partner. Choose
(3 seconds) or
short
value is
.
long
Note: HP recommends that you use a timeout value of
LACPDU processing. If your switch's CPU utilization rate remains at 100%
for periods of 90 seconds or more, consider using static trunks instead of
LACP.
Displays the LACP Port menu.
Display current LACP configuration.
off
Turn LACP off for this port. You can use this port to manually configure a
static trunk. The default value is off.
active
Turn LACP on and set this port to active. Active ports initiate LACPDUs.
passive
Turn LACP on and set this port to passive. Passive ports do not initiate
LACPDUs, but respond to LACPDUs from active ports.
(90 seconds). The default
long
, to reduce
long
Configuration Menu 121
Hide quick links:
Table of Contents
