Temporarily Disabling A Port; Port Link Configuration - HP GbE2c - Blc Layer 2/3 Fiber SFP Option Command Reference Manual
Hp gbe2c ethernet blade switch for c-class bladesystem command reference guide
Hide thumbs
Also See for GbE2c - Blc Layer 2/3 Fiber SFP Option:
- Interface manual (209 pages) ,
- Application manual (165 pages) ,
- Cli reference manual (153 pages)
Table of Contents
Temporarily disabling a port
To temporarily disable a port without changing its stored configuration attributes, enter the following command at any
prompt:
Main# /oper/port /dis
Because this configuration sets a temporary state for the port, you do not need to use apply or save. The port state
will revert to its original configuration when the switch is reset. See the "Menu information" section in the "Operations
Menu" chapter for other operations-level commands.
Port link configuration
Command: /cfg/port /gig
[Gigabit Link Menu]
Use these menu options to set port parameters for the port link.
Link menu options are described in the following table and display on the Gigabit port configuration menus for the
switch. Using these configuration menus, you can set port parameters such as speed, duplex, flow control, and
negotiation mode for the port link.
The following table describes the Gigabit Link Configuration Menu options.
Table 100
Gigabit Link Configuration Menu options
Command
speed 10|100|1000|any
mode full|half|any
fctl rx|tx|both|none
auto on|off
cur
speed
- Set link speed
mode
- Set full or half duplex mode
fctl
- Set flow control
auto
- Set auto negotiation
cur
- Display current gig link configuration
Description
Sets the link speed. Not all options are valid on all ports. The choices include:
10 Mb/s
100 Mb/s
1000 Mb/s
"any," for automatic detection (default)
Note: Ports 1-18 are set to 1000 Mb/s, and cannot be changed.
Sets the operating mode. Not all options are valid on all ports. The choices
include:
Full-duplex
Half-duplex
"Any," for automatic detection (default)
Note: Ports 1-18 are set to full duplex, and cannot be changed.
Sets the flow control. The choices include:
Receive (rx) flow control
Transmit (tx) flow control
Both receive and transmit flow control (default)
No flow control
Enables or disables auto-negotiation for the port.
Displays current port parameters.
Configuration Menu 108
Hide quick links:
Table of Contents
