11.2.9 Pediatric Calculations
11.2.9.1 Items of Pediatric Calculations
11.2.9.2 Before starting Pediatric Calculations
Note
11.2.9.3 Pediatric Calculations in 2D Mode
Voluson® S6/S8 Basic User Manual
5433669-100 Revision 4
For additional description please refer to Basic Patient Worksheet Functions
Patient Worksheet Functions'
Application "Pediatrics", (Factory - Sub Category: Default) allows measurements/calculations
in 2D/3D mode, M mode and Spectral-Doppler mode, using various measure items. For details
about settings, review: Measure Setup - Measure & Calc
on page 11-109 )
The methods for obtaining measurements in the Pediatrics Calculations menu are similar to
the generic measurement functions in 2D, M and Spectral Doppler mode.
The items of pediatric calculations in each mode are as follows:
2D/3D Mode
M Mode:
Doppler Mode:
1. Press the [Patient] key on the control panel, select the [PED] page and enter all patient
information for Pediatric calculations. For details refer to: Entering Patient Data
on page 4-10 )
'Entering Patient Data'
To cancel all calculations performed before and to start new measurement, press this key and
select [End Exam] or [Clear Exam].
2. Press [Start Exam].
3. Make sure that the probe and application are selected properly. If another application is
selected, press the [Probe] key on the control panel, and change it to Pediatrics. For details
refer to: Probe/Program Selection
•
Hip Joint
(chapter 'Hip Joint' on page 11-92 )
Measurements and Patient Worksheets (Reports)
on page 11-101 ) .
Hip Joint
not yet specified
not yet specified
(chapter 'Probe/Program Selection' on page 4-7 )
(chapter 'Basic
(chapter 'The Measure Setup Pages'
(chapter
11-91
Hide quick links:
Chapters
