11.2.2.2 Before starting Abdomen Calculations
Note
11.2.2.3 Abdomen Calculations in 2D Mode
11.2.2.4 Distance Measurements
Voluson® S6/S8 Basic User Manual
5433669-100 Revision 4
1. Press the [Patient] key on the control panel, select the [ABD] page and enter all patient
information for Abdomen calculations. For details refer to: Entering Patient Data
on page 4-10 )
'Entering Patient Data'
To cancel all calculations performed before and to start new measurement, press this key and
select [End Exam] or [Clear Exam].
2. Select [Start Exam].
3. Make sure that the probe and application are selected properly. If another application is
selected, press the [Probe] key on the control panel, and change it to Abdomen. For details
refer to: Probe/Program Selection
•
Distance Measurements
Length, Height, etc.)
•
Vessel Area/Vessel Diameter
•
Stenosis Area/Stenosis Diameter
11-28 )
To measure a distance in 2D mode:
Measurements and Patient Worksheets (Reports)
(chapter 'Probe/Program Selection' on page 4-7 )
(chapter 'Distance Measurements' on page 11-25 ) (like
(chapter 'Vessel Area/Vessel Diameter' on page 11-26 )
(chapter 'Stenosis Area/Stenosis Diameter' on page
(chapter
11-25
Hide quick links:
Chapters
