Bosch D9412GV3 Program Entry Manual page 73
Hide thumbs
Also See for D9412GV3:
- Installation instructions manual (28 pages) ,
- Quick reference manual (26 pages) ,
- Operation and installation manual (76 pages)
Table of Contents
D9412GV3/D7412GV3 | Program Entry Guide | 2.0
L## Bypass a Point
Default:
Refer to the program record sheet
Selection:
- or E
Function
Function Name
No.
25
Bypass a Point
Bypass points with this authority level.
L## Unbypass a Point
Default:
Refer to the program record sheet
Selection:
- or E
Function
Function Name
No.
26
Unbypass a Point
Unbypass points with this authority level.
L## Reset Sensors
Default:
Refer to the program record sheet
Selection:
- or E
Function Name
Function
No.
27
Reset Sensors
Reset sensors with this authority level.
L## Change Relay
Default:
Refer to the program record sheet
Selection:
- or E
Function Name
Function
No.
28
Change Relays
Manually activate or reset a system relay.
Do not use the Change Relays function
to toggle relays reserved for special
functions. Special function relays are
Area and Panel Wide Relay functions as
well as relays assigned to CC# Enter
Key Relay?
L## Remote Program
Default:
Refer to the program record sheet
Selection:
- or E
Function Name
Function
No.
29
Remote
Programming
Start a remote programming software (RPS) session
when the phone rings at the control panel.
Bosch Security Systems, Inc. | 10/11 | F01U170807-02
Panel and Area Wide Parameters
L## Move to Area
Default:
Selection:
Alternate
Function
Keystroke
No.
[COMMAND][0]
30
Temporarily switch to a different area and perform
keypad functions related to that area.
L## Display Rev
Default:
Selection:
Alternate
Keystroke
Function
[COMMAND][0][0]
No.
32
Display the control panel model name and software
revision. For example:
L## Service Walk
Alternate
Keystroke
Default:
[COMMAND][4][7]
Selection:
Function
No.
33
Start a Service Walk Test for all 24-hour Interior or
Perimeter Controlled points in the control panel.
Alternate
Keystroke
Points are not included in this test if:
[COMMAND][5][4]
When a Service Walk Test is initiated, one person
can test all the points in the control panel without
assistance. The following features are provided with
the Service Test Mode:
Alternate
Keystroke
[COMMAND][4][3]
Get other manuals https://www.bkmanuals.com
Refer to the program record sheet
- or E
Function Name
Move to Area
Refer to the program record sheet
- or E
Function Name
Display Software
Revision
9412GV3 REV ##.##
Refer to the program record sheet
- or E
Function Name
Service Walk
Test
Points are in an area that is already in a Walk
Test Mode.
Points are assigned to an area that is not
enabled A# Area On.
Points are in an area that is Master or Perimeter
armed.
Display indicates exactly how many points can be
tested.
Battery and bell tests do not occur during this
Walk Test.
The test ends when all points are tested or the
test times out after 20 min of inactivity.
EN | 73
Alternate
Keystroke
[COMMAND][5][0]
Alternate
Keystroke
[COMMAND][5][9]
Alternate
Keystroke
(Menu function
only)
Hide quick links:
Table of Contents
