Dishwasher Shuts Off; Can't Select Wash Cycle; Dishwasher Won't Drain - Bosch SHEM63W55N Repair Manual
Hide thumbs
Also See for SHEM63W55N:
- Installation instructions manual (88 pages) ,
- Operating instructions manual (88 pages) ,
- Quick start and safety manual (7 pages)
Table of Contents
Fault Diagnosis
Fault
Dishwasher shuts off
Can't select wash cycle
Dishwasher won't drain
Faulty or damaged parts
2020-04-24_58300000218396_ara_en_c
Possible cause
Supply voltage drops due to bad connections
¡
Far right LED flashes and
E:01
shows on display
¡
Loose power cord plug at power module or cus-
tomer outlet.
¡
Loose wiring to terminal block when optional junc-
tion box [SMZPCJB1UC] was used (instead of the
supplied power cord)
Open On / Off or Start switch
High supply voltage
¡
> 140 VAC
¡
Dishwasher turns off and
E:30
error code won't
show during wash cycle
Previous wash cycle hasn't completed or current wash
cycle was interrupted
Kinked drain hose
¡
Wash cycle completed prematurely
¡
Far right LED is lit and
E:24
shows on display
Leaky or faulty drain check valve
¡
Wash cycle completed prematurely
¡
Far right LED is lit and
E:24
shows on display
Copyright by BSH Hausgeräte GmbH
Troubleshooting
1. When the supplied power cord was used, make sure it's securely
plugged in at both ends. If it's faulty, replace it.
2. When a junction box kit was used, check wiring and tighten terminal
block screws.
Make sure wires are inserted above terminal clamps, with wire
insulation ~ 1 - 2 mm from clamps (i.e. don't insert wire insula-
tion into terminal clamps).
1. Check On / Off switch and power module connections.
2. Measure On / Off switch resistance.
If On / Off switch resistance = ∞ Ω when switch is in on position,
replace On / Off switch.
3. Open door and press On / Off switch.
If no LED's flash, replace operating module (in fascia panel).
1. Run test program to check error codes for an
2. Check house wiring connections. Make sure supply voltage is 98 -
120 VAC to power module (L to N, not L to ╧).
▶
Advise customer:
To complete wash cycle or reset dishwasher.
1. Straighten out drain hose.
2.
Drain hose is damaged, replace it.
▶
Drain check valve leaks or doesn't close, replace it.
E:30
error code.
Page 48 of 126
- Quick Links:
- Fault Diagnosis
Hide quick links:
Table of Contents
