Replacing Aqua Sensors; Removing Aqua Sensors; Installing Aqua Sensors - Bosch SHEM63W55N Repair Manual
Hide thumbs
Also See for SHEM63W55N:
- Installation instructions manual (88 pages) ,
- Operating instructions manual (88 pages) ,
- Quick start and safety manual (7 pages)
Table of Contents
Repair
6.21 Replacing aqua sensors
Required tools:
Torx T20 screwdriver
Phillips screwdriver PH2
Pliers
160 mm
¡
Access the aqua sensor (3) from the front of the dishwasher base by removing the
toe panel and base cover.
¡
Only pull out dishwashers enough to clear hinges.
Prerequisite:
Dishwasher disconnected and pulled out→ Page 76
Outer door removed→ Page 79
Toe panel removed→ Page 87
Front base insulation removed.
Base cover removed→ Page 88
6.21.1 Removing aqua sensors
1. Disconnect aqua sensor wire harness.
2. Lift up housing latch (1), twist aqua sensor counter-clockwise (2) and pull aqua
sensor out from sump (3).
2020-04-24_58300000218396_ara_en_c
6.21.2 Installing aqua sensors
▶
Insert aqua sensor into the sump with its pc board vertical (1), then rotate it clock-
wise (cw) until it locks into place (2).
[00341279]
[00341142]
Apply some rinse-aid onto the aqua sensor O-ring to lubricate it for easier in-
stallation.
Copyright by BSH Hausgeräte GmbH
Page 105 of 126
- Quick Links:
- Fault Diagnosis
Hide quick links:
Table of Contents
