Installation of EZ1/MS50/ML095 Mount Body
Prepare Mounting Site
The EZ-Touch was designed to be installed on a 16" on center 2" x 4" wood stud, or metal studs, using
high-quality hollow wall anchor installed in the center of the stud
or a solid concrete wall.
WARNING: INSTALLING THE MOUNT IN UNDERRATED OR DAMAGED CONCRETE CAN LEAD TO
SERIOUS INJURY OR DAMAGE TO PRODUCT! When installing into concrete only install the mount in a
solid concrete wall made of 2500 PSI (17.3 MPa)
or stronger concrete. Never install the mount into cracked, chipped or flaking concrete.
WARNING: IMPROPER INSTALLATION CAN LEAD TO MOUNT FALLING CAUSING SERIOUS
PERSONAL INJURY OR DAMAGE TO EQUIPMENT! It is the installers responsibility to make sure the
structure to which the EZ-Touch is being installed is capable of supporting three times the combined
weight of the EZ-Touch and all
attached equipment is not to exceed the following weight capacities:
EZ1/MB16/152: 90-152lbs / 40-69kg
Mounting EZ-Touch Mount Body to Wall
Unpack the EZ-Touch and remove the plastic cover and two foam blocks.
Locating your mount
WOOD CONSTRUCTION:
locate two framing studs (minimum of 16" (405 mm) apart) at the desired location using a stud
finder device.
MASONRY:
a minimum width of 16" (405 mm) is required between fasteners.
Salamander EZ-Touch Manual Lift Wall Mounts - EZ1/MS50/ML095
Remove Plastic Cover and Foam Blocks
Packing Foam
Block (2x)
Plastic Cover
Packing Foam
Block (2x)
Plastic Cover
501-765 [12.22]
page 4 of 10
