Never adjust the inner springs! Springs should be unattached before disposal of the EZ-Touch. Sort the EZ-Touch, the accessories and the packaging for the environmentally friendly recycling. Salamander EZ-Touch Manual Lift Wall Mounts - EZ1/MS50/ML095 501-765 [12.22] page 3 of 10...
Page 4
Remove Plastic Cover and Foam Blocks Unpack the EZ-Touch and remove the plastic cover and two foam blocks. Packing Foam Block (2x) Plastic Cover Packing Foam Block (2x) Plastic Cover Locating your mount WOOD CONSTRUCTION: locate two framing studs (minimum of 16” (405 mm) apart) at the desired location using a stud finder device. MASONRY: a minimum width of 16” (405 mm) is required between fasteners. Salamander EZ-Touch Manual Lift Wall Mounts - EZ1/MS50/ML095 501-765 [12.22] page 4 of 10...
Page 5
16in Adjustable Range 406mm 79.5in 82.88in 2019mm 2105mm 41.2in Approx. Lowest 1046mm Screen Position Mounting bracket level to wall Unpack the EZ-Touch Take the wall bracket out (A) of the box. Note the slotted/slanted holes for level wall mounting. LOCK SCREW HOLE 11.8" 16” Salamander EZ-Touch Manual Lift Wall Mounts - EZ1/MS50/ML095 501-765 [12.22] page 5 of 10...
Page 6
Make sure screws are unlocked Lift the mount onto bracket ools needed Salamander EZ-Touch Manual Lift Wall Mounts - EZ1/MS50/ML095 501-765 [12.22] page 6 of 10...
Page 7
Lock mount with screws Level vertically with feet at the bottom Salamander EZ-Touch Manual Lift Wall Mounts - EZ1/MS50/ML095 501-765 [12.22] page 7 of 10...
Page 9
M4 x 12mm (10x) or M6 x 12mm (10x) or M8 x 12mm (10x) M6 x 12mm (4x) M8 x 10mm (4x) Hang display onto horizontal bracket and level Salamander EZ-Touch Manual Lift Wall Mounts - EZ1/MS50/ML095 501-765 [12.22] page 9 of 10...
Page 10
BRACKET INSTALLATION POINTS AS SHOWN 1/2” 10mm 13mm Never adjust the inner springs! It may be necessary to tighten if balanced point is exceeded. SALAMANDER WARRANTY LIMITED WARRANTY FOR COMMERCIAL VIDEO DISPLAY STANDS AND MOUNTS Salamander warrants against manufacturing defects for two (2) years from the date of purchase. Salamander will repair or replace, at our option, any product defective in materials or craftsmanship. Batteries are not covered by the warranty. Full warranty including limitations and warranty claim information may be found at www.salamandercommercial.com Subject to printing errors and technical amendments. Salamander EZ-Touch Manual Lift Wall Mounts - EZ1/MS50/ML095 501-765 [12.22] page 10 of 10...