How to use this manual
1
Read manual carefully before you install the mount
2
Carry out the actions fully and in the given sequence
3
The mount guarantee is voided if the product is not correctly installed
or modified in any way
Warning symbols used
A
Sharp edges
B
Wear glove
C
Physical load
D
Two people required
E
Entanglement hazard
F
Warning: Can cause personal
injury or equipment damage
Intended use
The EZ-Touch Mount is a system that compensates the mass of vertically moving displays to
ease vertical movement of the display.
General warning
The display may only be attached to or removed from the EZ-Touch when the
EZ-Touch is in closed position. The EZ-Touch is under strong spring force. Only operate
the EZ-Touch with an adequately balanced display attached to the display frame.
Do not remove any parts of the EZ-Touch. Only the finishing cover can be removed.
Mounting fasteners
Mounting fasteners are not included with the product. Obtain advice from a specialist.
Setting the springs
Adjust only the outer springs:
•
Adjust the height of the outer springs equally
•
Make sure that the height of the display is balanced
•
Increase the spring tension as much as possible
•
Make sure that the display does not move up
Never adjust the inner springs
Disposal of the EZ-Touch
Springs should be unattached before disposal of the EZ-Touch. Sort the EZ-Touch,
the accessories and the packaging for the environmentally friendly recycling.
Salamander EZ-Touch Manual Lift Wall Mounts - EZ1/MS50/ML095
A
B
D
E
Never adjust the inner springs!
C
F
501-765 [12.22]
page 3 of 10
