Table of Contents
1.4 Reverse Process to Change Auto Sipper to 6 Cell Turret
1.4 Reverse Process to Change Auto Sipper to 6 Cell Turret
1.4.1 Unplugging power cord
1.4.2 Dismounting Auto Sipper
Follow the procedures below to dismount the Auto Sipper from the
sample compartment section of the spectrophotometer, and mount
the 6 cell turret back in place.
(1) Turn off the power of the spectrophotometer main unit. The
power switch light goes out.
(2) Unplug the power cable from the receptacle.
Perform the procedure in the reverse order of the fixing operation.
(1) Loosen two guide screws using the slotted screwdriver, which is
an accessory to the spectrophotometer. In handling the Auto
Sipper, hold the handle and the upper portion of the front panel.
Fig. 1-28 Loosening Guide Screws
1 - 16
Guide screws
Table of Contents
