Connecting The Device; Notes On Connecting - Siemens SIMATIC IPC477D Operating Instructions Manual
Hide thumbs
Also See for SIMATIC IPC477D:
- Operating manual (54 pages) ,
- Operating instructions manual (292 pages) ,
- Quick install manual (2 pages)
Table of Contents
Mounting and connecting the device
3.4 Connecting the device
1. Remove the screws
2. Open the terminal compartment cover and set it aside safely.
3. If there is an intermediate plate in the adapter set: Fasten the intermediate plate
support arm head
Check that the seal is properly seated.
4. If there is an intermediate plate in the adapter set: Fasten the base adapter
intermediate plate
Check that the seal is properly seated.
5. If there is no intermediate plate in the adapter set: Fasten the base adapter
coupling of the support arm head
set.
6. Fasten the device
head screws from the Siemens base adapter set. Make sure that all connecting cables
are fed through the adapter into the interior of the device without damage.
7. Connect the device.
8. If you connect the device at a later time, fasten the terminal compartment cover to the
device.
3.4
Connecting the device
3.4.1
Notes on connecting
Risk of fire and electric shock
The on/off switch does not isolate the device from the power supply. Risk of electric shock if
the device is opened incorrectly or defective. There is also a risk of fire if the device or
connecting lines are damaged.
You should therefore protect the device as follows:
• Always pull out the power plug when you are not using the device or if the device is
• Connect the device to a protective conductor as instructed, see section "Connecting the
• Use a central isolating switch in the case of cabinet installation.
54
⑤
①
from the bottom with four M6 x 12 screws from the adapter set.
②
from below using the four M6 x 12 screws from the adapter set.
④
to the base adapter
WARNING
defective. The power plug must be freely accessible.
protective conductor".
of the terminal compartment cover.
①
from below using the four screws from the adapter
③
from the top with four M4 x 12 countersunk
SIMATIC IPC477D, IPC477D PRO
Operating Instructions, 07/2015, A5E31347228-AD
②
to the
③
to the
③
to the
Table of Contents
