Table of Contents
Quick Links
GE Monogram
Installation
Instructions
Professional
Ranges
48" Natural Gas Models
ZDP48N4G
ZDP48N6R
ZDP48N6D
48" LP Gas Models
ZDP48L4G
ZDP48L6R
ZDP48L6D
36" Natural Gas Models
ZDP36N6
ZDP36N4R
ZDP36N4D
36" LP Gas Models
ZDP36L6
ZDP36L4R
ZDP36L4D
30" Natural Gas Model
ZDP30N4
30" LP Gas Model
ZDP30L4
®
Table of Contents
Related Manuals for GE Monogram ZDP30L4HSS
Summary of Contents for GE Monogram ZDP30L4HSS
- Page 1 ® GE Monogram Installation Instructions Professional Ranges 48" Natural Gas Models ZDP48N4G ZDP48N6R ZDP48N6D 48" LP Gas Models ZDP48L4G ZDP48L6R ZDP48L6D 36" Natural Gas Models ZDP36N6 ZDP36N4R ZDP36N4D 36" LP Gas Models ZDP36L6 ZDP36L4R ZDP36L4D 30" Natural Gas Model ZDP30N4 30"...
-
Page 2: Table Of Contents
Installation of this range requires basic electrical, carpentry and mechanical skills. Proper installation is the responsibility of the installer. Product failure due to improper installation is not covered under the GE Appliance Warranty. See the Owner’s Manual for details. grounding must comply with applicable codes. -
Page 3: Models Available
All models require the installation of a back- Accessory guard. A backguard should be ordered at the Requirements same time as the range. Both must be on site at the time of installation. Order one backguard for 48" Models: ZX1B48 1-1/2"... -
Page 4: Models Dimensions And Clearances
36" Min. High to Combustibles Shelf Low Back 0" Clearance 26" 28-1/4" 31-1/2" 45-5/8" 48" and 36" Range Models Professional Ranges 21-1/4" 12" 1-1/2" 28-1/4" 35-7/8" 36" Wide Range Models 12" Min. to Combustibles Without Backguard or 0" to Non-Combustible Wall with 1-1/2"... - Page 5 48" Wide Models 16" 18" Min. 30"/36" Wide Models 4" 12" 48" Wide Models 8" 3-1/4" 3-1/2" Gas Supply 35-3/8" Max. for Counter Level 36-3/4" Max. with Range Leveling Legs Fully Extended Professional Ranges 27-3/8" 12" 3-1/4" High 21-1/4" to Combustibles Shelf 9"...
-
Page 6: Advance Planning
1200 CFM. –For 30" and 36" models, we recommend the vent hood blower be 600 CFM. • Working areas adjacent to the range should have 18" minimum clearance between countertop and cabinet bottom. • Clearance between range and side wall or combustible material must be at least 12"... -
Page 7: Installation Preparation
NEMA 14-50R devise to accept the 4-prong plug supplied with the range. CAUTION WARNING The range is equipped for use with an electrical supply which uses a separate grounding conductor (4 wire system). If this range must be connected to an... -
Page 8: Installation
• Remove the kick panel by removing 2 screws at the top and pulling forward. The range is secured to the skid with 2 bolts in the front and 2 “L” brackets on the bottom flange of the range back. Remove bolts and “L”... -
Page 9: Step 2: Level The Range
CAUTION WARNING instructions. • If the range is pulled out from the wall for any reason, make sure that the device is • All Ranges Can Tip properly engaged when pushed back against the wall or installation position. - Page 10 S tep Install Anti-Tip Small Holes For Wood Installations (2 Total) Device (continued) Wood Slide Strip Wood Construction: • Place the bracket against the back wall, into the right rear corner of the installation location. • See Dimension A, position the bracket the correct distance from the right side.
-
Page 11: Step 4: Connect Range To Gas
Gas the range. • Pull the flexible metal gas line through the back of the range and into the cooking area until it meets the regular. • Connect flexible metal connector to incoming gas line pipe stub. -
Page 12: Step 6: Connect Electrical
Into • Check to be sure the front of the range is Position level. Adjust front leveling legs accordingly. • Replace the front kick panel by reversing the proceedure described in Step 1. -
Page 13: Step 9: Assemble & Adjust Burners
• Replace the burner bowls and burner caps. • Adjustments should not be required, unless vibration during transit or variations in local Step gas supply make minor adjustments neces- sary. Assemble & Adjust CAUTION: Burner adjustments must be made by a qualified technician at the time of installa- Burners tion. - Page 14 Notes Professional Ranges...
- Page 15 Notes Professional Ranges...
- Page 16 Note: Product improvement is a continuing endeavor at General Electric. Therefore, materials, appearance and specifications are subject to change without notice. Monogram. ® We bring good things to life. GE Consumer Products General Electric Company Louisville, KY 40225 © 2003 General Electric Company...