Cisco Firepower 1010 Getting Started Manual page 114
Hide thumbs
Also See for Firepower 1010:
- Hardware installation manual (40 pages) ,
- Configuration note (21 pages) ,
- Configuration manual (12 pages)
Table of Contents
Add the Default Route
• Type—Click the IPv4 or IPv6 radio button depending on the type of static route that you are adding.
• Interface—Choose the egress interface; typically the outside interface.
• Available Network—Choose any-ipv4 for an IPv4 default route, or any-ipv6 for an IPv6 default route
and click Add to move it to the Selected Network list.
• Gateway or IPv6 Gateway—Enter or choose the gateway router that is the next hop for this route. You
can provide an IP address or a Networks/Hosts object.
• Metric—Enter the number of hops to the destination network. Valid values range from 1 to 255; the
default value is 1.
Step 3
Click OK.
The route is added to the static route table.
Cisco Firepower 1010 Getting Started Guide
112
Firepower Threat Defense Deployment with FMC
Hide quick links:
Table of Contents
