Wenn ein Ersatz der Anschlussleitung erforderlich ist, dann tro- und Elektronik-Altgerä t e und ihrer Umsetzung in natio- ist dies von Bosch oder einer autorisierten Kundendienst- nales Recht mü s sen nicht mehr gebrauchsfä h ige Elektro- stelle für Bosch-Elektrowerkzeuge auszuführen, um Sicher- werkzeuge getrennt gesammelt und einer umweltgerechten heitsgefährdungen zu vermeiden.
Page 5
If devices are provided for the connection of dust ex- Just because the accessory can be attached to your traction and collection facilities, ensure these are con- power tool, it does not assure safe operation. 1 609 92A 5FG | (25.03.2020) Bosch Power Tools...
Page 6
Do not run the power tool while carrying it at your The grinding surface of centre depressed wheels must side. Accidental contact with the spinning accessory be mounted below the plane of the guard lip. An im- Bosch Power Tools 1 609 92A 5FG | (25.03.2020)
Failure to observe the safety and general in- may cut gas or water pipes, electrical wiring or objects that can cause kickback. structions may result in electric shock, fire and/or serious injury. 1 609 92A 5FG | (25.03.2020) Bosch Power Tools...
Page 8
EN 60745-2-3: EN 60745-2-3. Surface grinding (roughing): Typically the A-weighted noise level of the power tool are: 91 = 6.5 m/s , K = 1.5 m/s dB(A); sound power level 102 dB(A). Uncertainty K = 3 dB. Bosch Power Tools 1 609 92A 5FG | (25.03.2020)
Page 9
See the graphics page for assembling instructions. tool can be fitted. To fasten the grinding/cutting disc, screw on the clamping nut (12) and tighten with the two-pin spanner; see the Quick-clamping nut section. 1 609 92A 5FG | (25.03.2020) Bosch Power Tools...
Page 10
When screwing on, make sure that the printed side of the 11000 quick-clamping nut (13) is not facing the grinding disc; the arrow must be pointing towards the index mark (24). – 11000 Bosch Power Tools 1 609 92A 5FG | (25.03.2020)
Cutting Cutting disc Stone Cutting Diamond cutting disc and cutting guide (cutting of stone is permit- ted only with a cutting guide) The values specified for speed levels are guide values. 1 609 92A 5FG | (25.03.2020) Bosch Power Tools...
Maintenance and Service Maintenance and cleaning Pull the plug out of the socket before carrying out any work on the power tool. Bosch Power Tools 1 609 92A 5FG | (25.03.2020)
Page 13
Johannesburg In order to avoid safety hazards, if the power supply cord Tel.: (011) 4939375 needs to be replaced, this must be done by Bosch or by an Fax: (011) 4930126 after-sales service centre that is authorised to repair Bosch E-Mail: [email protected]...