Hints For Great-Tasting Coffee - Electrolux E2CM1-200W Instruction Book

Table of Contents

Available languages

left by the water according to the water quality in your area and the use frequency. We recommend

decalcifying your coffee maker as follows, using a solution of white vinegar and cold water. A solution of

two tablespoons (30ml) white vinegar in one carafe of cold water works best.

1. Fill the tank with the vinegar solution to the maximum level as indicated on water gauge.

2. Insert glass carafe onto the warming plate.

3. Make ensure paper filter (without coffee powder) and funnel are assembled in place.

4. Switch on the appliance and allow it to "brew" de-scaling solution.

5. After "brew" one-cup solution, switch off the appliance.

6. Leave the solution stay for 15 minutes and repeat step 3-5.

7. Switch on the appliance and run off the solution until the water tank is completely empty.

8. Rinse by operating the appliance with water at least 3 times.

HINTS FOR GREAT-TASTING COFFEE

1. A clean coffee maker is essential for making great-tasting coffee. Regularly clean the coffee maker as

specified in the "CARE AND CLEANING" section. Always use fresh, cold water in the coffee maker.

2. Store unused coffee powder in a cool, dry place. After opening a package of coffee powder, reseal it

tightly and store it in a refrigerator to maintain its freshness.

3. For an optimum coffee taste, buy whole coffee beans and finely grind them just before brewing.

4. Do not reuse coffee powder since this will greatly reduce the coffee' flavor. Reheating coffee is not

recommended as coffee is at its peak flavor immediately after brewing.

5. Clean the coffee maker when over-extraction causes oiliness. Small oil droplets on the surface of

brewed, black coffee are due to the extraction of oil from the coffee powder.

6. Oiliness may occur more frequently if heavily roasted coffees are used.

DISPOSAL

www.electrolux.com

You can help protect the environment!

Please remember to respect the local regulations: hand in the non-working

electrical equipments to an appropriate waste disposal center.