Available languages
Available languages
Care & Cleaning
(Before cleaning, be sure to disconnect the power plug from outlet, dispense water and cool down the unit.)
Main unit and lid
Clean with a damp, well-wrung cloth.
Do not wet or soak the main unit in water.
If water enters the main unit from the bottom or
(
from the dispensing spout, it can also get into
the electrical components in the main unit and
may cause a malfunction.
Do not use detergents. (They may leave an odor.)
Do not use benzine or thinner. (They may damage the surface.)
Inner container
Clean with a wet soft sponge.
Do not use polishing
powder, a scrub brush or a
nylon brush.
They may damage the fluororesin finish
(
of the inner container.
About "Scale"
While you are using this unit, minerals
contained in the water (like calcium) can get
stuck on the inner container or on the mesh
filter. This is called "scale", and it is harmless.
Milky-white gritty surface (caused by calcium)
White or glittering floating material
(crystals of minerals)
Discoloration in the finish like dark brown,
gray, or green areas
(metallic ion made on the fluororesin covering)
These are not discoloration or corrosion of the
inner container itself, nor are they flakes from
the fluororesin covering.
Clean the inner container using citric acid.
(õ. EN13)
Ceramic filter
Shake in water roughly every
few months, and scrub the
surface with soft sponges.
Do not wash with detergent.
(It causes odor remain)
Do not use dishwasher with dryer or dish
dryer. (It causes deformation)
Mesh filter
Clean the filter with a brush.
When filter is clogged, water
does not flow smoothly.
* After cleaning the filter, be
sure to reattach it to the
inner container.
EN12
Daily
Clean with
Maintenance
Citric Acid
)
)
When storing the unit
Dry it thoroughly.
Put it into a plastic bag and seal the bag to
keep insects from getting in.
Once every two or three months to clear scale.
How to clean with citric acid
1
Make sure that the mesh filter is attached to the inner container.
2
Put citric acid in the inner container.
Amount of citric acid to be used at one time:
80 g (two packages) or seven level tablespoons.
For purchasing our citric acid, contact us using the contact list in the warranty.
(Part No: SAN-80N)
* Follow the directions for cleaning printed on the citric acid package.
* Since the citric acid used for cleaning is a food additive, it is harmless to humans.
3
Add water to the maximum water level mark,
and mix the citric acid and water well. Close the
lid.
4
Connect the power plug, and choose "Cleaning" by pressing
Cleaning start
Light on
Light off
It rotates during cleaning.
5
Dispense some hot water, then unplug, remove the lid and drain away the hot water
via the
mark. (õ. EN8)
DRAIN
6
Refill with water and boil it to remove the smell of the citric acid.
Then throw the hot water away in the same way as step 5.
To remove any discoloration from the area above the maximum water level, rub the inside lightly
with a wet soft sponge.
If the discoloration cannot be removed by rubbing, clean the inner container several times using citric acid.
When washed without removing ceramic filter, wash the ceramic filter under running water and fix
it in the inner container. Boil water and drain away.
Requests
Make sure only use pure citric acid for thermo pot washing.
Do not fill water above maximum water level.
Fill the inner container only with water (do not fill with hot water). Hot water may spout out
causing burns.
Citric acid
.
peep peep
peep peep
End of cleaning
Flashing
Light off
simultaneously
EN13
