Installing Exterior Assembly - Honeywell 8812309S User Manual

8. INSTALLING THE EXTERIOR ASSEMBLY

Work with the Door Open for easy access.

a. Unpack the Exterior Assembly. Use care to not scratch the green circuit board during handling and installation.

b. Check that the Rubber Gasket is properly seated on the Exterior Assembly (Figure 8a).

c. Insert the Exterior Assembly onto the door with the tailpiece going through the Deadbolt Latch Set cross

shaped spindle connector in the VERTICAL POSITION. Route the Control Wire through the door under the

Deadbolt Latch Set (Figure 8c).

Rubber

Gasket

Figure 8a

9. SECURING THE EXTERIOR ASSEMBLY TO THE DOOR

a. From the side marked "This side against

door", route the Control Wire through the

rectangular slot in the Mounting Plate

(Figure 9a).

b. Place Mounting Plate against door with tailpiece passing

through the center hole in the three hole set (Figure 9b).

c. Secure the Mounting Plate to the Exterior Assembly using

two 7/8" (22mm) Screws (Figure 9c).

d. Hand tighten with a Phillips Screwdriver leaving loosely connected (Figure 9d).

e. Check that the Rubber Gasket is properly aligned and correct as necessary (Figure 8a).

f. Check vertical alignment of the lock (Figure 9f).

g. Tighten securely with a hand held Phillips Screwdriver. DO NOT OVER TIGHTEN

10. OPTIONAL INSTALLATION

a. Using a 1/16" (2mm) drill bit, drill a pilot hole in your door using the

Mounting Plate upper hole as a guide (Figure 10a).

b. Insert one 3/4" (19mm) screw and tighten.

Tailpiece

(Vertical)

Figure 8c

NOTE: Lock and unlock using the key to see if

the Deadbolt Latch is opening and closing easily.

Latch Hole

Control

Wire

3/4"(19mm) screw

(Optional Instalation)

6

NOTE: Tailpiece must be

positioned vertically

Mounting Plate

C

7/8"(22mm) screws

B

Control Wire

Right handed door view

Figure 9a-f

Figure 10a