GE Vivid T8 Basic Service Manual page 132
Hide thumbs
Also See for Vivid T8:
- Basic service manual (349 pages) ,
- Technical publication (127 pages) ,
- Material safety data sheet (2 pages)
Table of Contents
System Setup
3-9-3 Setup connection to a DICOM server(continued)
CAUTION
NOTE:
NOTE:
3-48
In Image Settings, setting compression to None may lead to
very long transfer time and loops larger than 500s frames will
be trucated. In case it happens, a warning is displayed on the
screen.
The pull-down menu gives these chioces:
•
Jpeg - JPEG/JPG compression (Default). JPEG is not
lossless.
•
None - (un-compressed data with huge files)
If you are using compression None, it is strongly
advised to reduce Frame Rate to 25 or 30 to avoid
truncating loops.
•
Rle - Run Length Encoding. This is lossless
compression.
•
Quality % - Set the wanted quality %. Default value is
95%.
If files are stored with a quality lower than 95% they will
occupy less space, but loose some quality.
Setting the quality % too low may add too much artifacts
to the images that they cannot be used for diagnosis.
If files are stored with a quality above 95%, the files will
grow much larger without almost no quality change.
Figure 3-35. DICOM SR Settings
•
Allow SR
If SR is enabled, all M&A that is supported by DICOM is
sent to the DICOM server (in a seperate job).
•
Allow SR Private Data
By default, this function is disabled. It is intended for
receivers that can handle "Private Data", such as
CA-1000.
•
Signed Doppler Velocities
It is disabled by default. It means that signs for Doppler
Velocities are removed in the DICOM SR.
Vivid T8/Vivid T8 Pro – Basic Service Manual
5718826-100 English Rev. 10
Table of Contents
