Team Losi LOSB0221 Getting Started

Mini-late model rtr

nOte:

Step 1

Plug the AC charger into the proper wall receptacle

(110V). Plug the battery pack into the charger and

let it charge for 3 hours for the first time. After

running, or when the Mini-Late Model slows

noticeably, recharge the battery pack for 5 to 6

hours for a full charge.

Step 3

Once the battery is charged, remove the body clip

from the front battery hold-down and remove the

battery strap (fig. 1).

GettinG Started

Before you start running your new Mini-Late Model, it is absolutely

necessary that you read through all of the operating instructions to prevent

unnecessary damage and get the maximum enjoyment from your vehicle.

Reinstall the battery strap and body clip. Plug

the battery pack into the ESC (fig. 3).

Step 2

Remove the transmitter battery cover by sliding the

cover from left to right. Install four (4) AA batteries

into the battery holder. Pay close attention to the

correct direction of the positive (+) and negative (-)

ends as marked in the tray. Once all 4 batteries have

been installed, reinstall the battery cover by sliding it

on from right to left.

Install the charged battery pack into the chassis as

shown (fig.2). Ensure that the battery is laying flat on

the chassis.

Page 1

Page 1 GettinG Started Before you start running your new Mini-Late Model, it is absolutely nOte: necessary that you read through all of the operating instructions to prevent unnecessary damage and get the maximum enjoyment from your vehicle. Step 1 Step 2 Plug the AC charger into the proper wall receptacle (110V).
Page 2 Step 5 Step 6 Although set at the factory, below are the steps required to re-bind your transmitter to the receiver should the need arise. During the bind process there is a unique ID from the transmitter communicated to the receiver to ensure trouble-free radio operation.