Cisco TelePresence MXP Series
Contents
Introduction
MENu ADDRESS
Control Panel >
EAP-TTLS
Network >
ON:
The EAP-TTLS protocol is enabled. Default mode is On.
LAN Settings >
OFF:
The EAP-TTLS protocol is disabled
IEEE 802.1X SETTINGS
Control Panel >
EAP-PEAP
Network >
ON:
The EAP-PEAP protocol is enabled. Default mode is On.
LAN Settings >
OFF:
The EAP-PEAP protocol is disabled
IEEE 802.1X SETTINGS
Control Panel >
NAME
Network >
There are 7 network profiles. The first 4 are predefined and the next 3 are user defined. If applicable,
NETWORK PROFILES
add a Call Prefix and/or Call Suffix. The prefix or suffix to a profile it will automatically be added to the
number being dialled. Enter the Name and Network type for the Network Profiles 5, 6 or 7.
Example: "System"
CALL PREFIX
Control Panel >
Network >
A Call Prefix can be added for each profile. Using Call Prefix is convenient if you have a fixed prefix for
NETWORK PROFILES
your service provider. If you add a prefix to a profile, this prefix will automatically be added in front of the
number being dialled.
Example: Add "0" as a Call Prefix to the 2nd profile, ISDN. If you enter "12345678" in the dial menu and
select ISDN, the number dialed will be "012345678".
Control Panel >
CALL SuFFIX
Network >
A Call Suffix can be added for each profile. If you add a suffix to a profile, this suffix will automatically be
NETWORK PROFILES
added in the end of the number being dialled.
Example for usage with a Border Controller:
You want to dial someone at company.com, then you can set the suffix: @company.com. When you dial
a person, the actual dial string will be [email protected]
Control Panel >
NETWORk
Network >
When using the Network Profiles 5, 6 and 7 you can make a Network selection for the profile.
NETWORK PROFILES
AuTO:
When set to Auto the system will parse (analyze) the number to dial and decide what network to
use based on this
H.320:
Select H.320 for an ISDN network
H.323:
Select H.323 for an IP network
SIP:
Select SIP for a SIP network
D14791.01 MXP Series Administrator Guide F90, August
Copyright © 2010-2011 Cisco Systems, Inc. All rights reserved.
Getting started
SETTINGS DESCRIPTION
2011.
The menu structure
The settings library
The settings library
85
Appendices
INFORMATION
EAP - Extensible Authentication Protocol
TTLS - Tunneled Transport Layer Security
EAP - Extensible Authentication Protocol
PEAP - Protected Extensible Authentication Protocol
Using * (asterisk) in the dial string.
When dialing with MXP, a single * is used by the system to
indicate the following sub number. In this case the * will not
be part of the dial string. It is possible to insert a * in the dial
string by using the escape sequence \* (backslash asterisk)
needed by some switches. A single * will work like before
indicating a sub number. The new escape sequence can
be used directly in the dial string in the 'Call Prefix' or 'Call
Suffix'. The escape sequence will not work for the second
number and sub number.
Some systems do not have ISDN (H.320). This applies to the
1700 MXP and NET versions of 3000/990/880 MXP.
Administrator guide
Contact us
PRODuCT
All
All
All
All
All
All
www.cisco.com
