Cisco TelePresence MXP Series
Contents
Introduction
System upgrade,
continued..
using ISDN
The TANDBERG MXP systems can be software upgraded in three
different ways:
•
Using Web Interface
•
Using FTP
•
Using ISDN
Software File
Before starting the software upgrade of the TANDBERG MXP
system, please make sure to have the new Software File, (for
instance s050000F30.pkg).
Your TANDBERG Partner will provide this for you.
Release key
Before starting the software upgrade of the TANDBERG MXP
system, please make sure to have the Release Key for this
software available.
Your TANDBERG Partner will provide this for you.
Backup
All options and settings will automatically be stored when
upgrading, so no backup is necessary.
What happens If the upgrade is interrupted
If the system upgrade process is aborted before it's complete, the
system will work as normal with the original software.
D14791.01 MXP Series Administrator Guide F90, August
Copyright © 2010-2011 Cisco Systems, Inc. All rights reserved.
Getting started
About far end ISDN system upgrade
NOTE!
Far end software upgrade is only possible when in an ISDN
conference with one other far end endpoint. Both systems must
be on software version F3.0 or newer for this functionality.
The system upgrade procedure
To upgrade using the web interface, please do the following steps
1.
Connect to the system that shall be upgraded using ISDN
2.
Copy the new software file to a folder on your computer, for
instance c:\software.
3.
Type the IP address of the TANDBERG MXP system that the
software upgrade is going to be done from (for instance
10.0.8.77) in a standard browser, such as Internet Explorer 6.0.
The web interface of the codec will then be displayed.
4.
Select the
System Configuration
then the sub-tab
2011.
The menu structure
The settings library
tab on top of the page, and
Far end
upgrade.
143
Administrator guide
Appendices
Appendices
5.
Enter the release key for the system to be upgraded in the
'Release Key' field. If no release key is given, the Far End
System will use the previously stored release key if possible.
This will work when upgrading from a main release to a dot
release.
6.
Make sure the setting "Far End System Upgrade" is set to "On"
at the remote site. This setting can be found in the Settings/
General/Permissions menu.
7.
Enter the password set at the far end for remote upgrade
(default password is "TANDBERG")
8.
Press 'Install Software' .The system will now use about 90% of
the call capacity to transfer the software file across. During this
time, audio and video will be turned off.
9.
Once the software has been transferred and verified at the
far end, you will get a new webpage with information that the
upgrade of the far end was successful. At the same time, a
message box will appear at the remote system asking if you
want to reboot the system to activate the new software.
10.
To activate the new software. The ISDN connection needs to
be closed, and the TANDBERG MXP system must be rebooted.
In the menu on the system under 'Control Panel/System
Information', the installed software should now be displayed as
the 'Software Version'.
Contact us
www.cisco.com
