Configuring Ethernet Communications - GE Multilin 489 Instruction Manual
Generator management relay
Hide thumbs
Also See for Multilin 489:
- Instruction manual (306 pages) ,
- Communications manual (78 pages) ,
- Instruction manual (259 pages)
Table of Contents
CHAPTER 4: INTERFACES
4.3.3
Configuring Ethernet Communications
489 GENERATOR MANAGEMENT RELAY – INSTRUCTION MANUAL
Courtesy of NationalSwitchgear.com
Press the Quick Connect button.
The following window will appear:
As indicated by the window, the Quick Connect feature quickly connects the EnerVista 489
Setup software to a 489 front port with the following setpoints: 9600 baud, no parity, 8 bits,
1 stop bit.
Select the PC communications port connected to the relay.
Press the Connect button.
The EnerVista 489 Setup software will display a window indicating the status of
communications with the relay. When connected, a new Site called "Quick Connect" will
appear in the Site List window. The properties of this new site cannot be changed.
The 489 Site Device has now been configured via the Quick Connect feature for serial
communications. Proceed to Connecting to the Relay on page 4–19 to begin
communications.
Before starting, verify that the Ethernet cable is properly connected to
the RJ-45 Ethernet port.
4–17
Table of Contents
