Table of Contents
Limitless™ WDRR Receiver
Try several mounting locations and/or antennas along with retesting each with the attenuator to determine the
optimal set-up that provides an acceptable fade-margin. Remove the attenuator after testing is completed.
*Suggested sources/part numbers
•
10 dB attenuator (i.e. Crystek – Part number: CATTEN-0100)
•
RP-SMA female to SMA male connector adaptor (i.e. Connector City – Part number : ADP-SMAM-RPSF)
•
RP-SMA male to SMA female connector adaptor (i.e. Connector City – Part number : ADP-RPSM-SMAF)
9
WDRR Mounting
The WDRR is intended to be mounted to a Din-Rail or mounted via the housing's four (4) mounting tabs.
9.1 Din-Rail mounting:
The WDRR receiver is supplied with two snap-in Din-Rail tabs that need to be inserted into the back of the WDRR
housing as shown below.
Figure 24. Limitless™ WDRR Mounting Clips
9.2 Tab mounting:
The WDRR has four tabs intended to allow mounting with a #6 style screw. As there are many types of screw
fasteners, care should be taken to not overtighten the fastener and cause the mounting tab/housing to crack or
fracture. Also, ensure that the housing is being mounted on a flat surface.
Figure 25. Limitless™ WDRR Mounting Tabs
50063987
Issue 1,
Honeywell Sensing and Control 33
Hide quick links:
Table of Contents
