Honeywell Limitless WDRR Series Quick Start Manual

Quick Start Guide for the

Limitless™ Series WDRR Receiver

WARNING

PERSONAL INJURY

• DO NOT USE these products as safety or emergency

stop devices or in any other application where failure of

the product could result in personal injury.

Failure to comply with these instructions could result in

death or serious injury.

WARNING

Honeywell does not recommend using devices for critical

control applications where there is, or may be, a single point

of failure or where single points of failure may result in an

unsafe condition. It is up to the end-user to weigh the risks

and benefits to determine if the products are appropriate for

the application based on security, safety and performance.

Additionally, it is up to the end-user to ensure that the

control strategy results in a safe operating condition if any

crucial segment of the control solution fails.

Honeywell customers assume full responsibility for learning

and meeting the required Declaration of Conformity,

Regulations, Guidelines, etc. for each country in their

distribution market.

Failure to comply with these instructions could result in

death or serious injury.

Sensing and Control

WARNING

RF EXPOSURE

• To satisfy FCC RF exposure requirements for mobile

transmitting devices, a separation distance of 20 cm or

more should be maintained between the antenna of this

device and persons during device operation To ensure

compliance, operation at closer than this distance is not

recommended. The antenna used for this transmission

must not be co-located in conjunction with any other

antenna or transmitter.

Failure to comply with these instructions could result

in death or serious injury.

WARNING

• The WDRR must be installed in accordance with the

requirements specified in this document in order to

comply with the specific Country Communication

Agency requirements. (i.e. FCC, IC, ETSI, ACMA, etc.)

See Section 3 as it requires choosing the correct

Country Use Code and thus allowable antenna and/or

cable usage.

CAUTION

• Power to the WDRR should not be applied during

installation of antenna as damage could occur to the

WDRR electronics.

CAUTION

* The WDRR receiver offers optimal performance when

paired with Limitless™ inputs that have a firmware

version of 7170 or a greater number (i.e., FW7170 will

be printed on the Limitless™ input label). If the

Limitless™ input is paired with older firmware (FW7170

or a lesser number), the WDRR may exhibit delayed

responses under simultaneous operation.

Issue 2

50063986