Remove And Replace The Fan Module - Cisco Firepower 4100 Series Maintenance And Upgrade Manual

If you install a network module that is a different PID than the original network module, the saved

Note

configuration is deleted and the default configuration is applied. You must enter the acknowledge command

to confirm the network module PID change.

What to do next

Follow the procedures in the

that it has been discovered correctly by the Firepower 4100.

Remove and Replace the Fan Module

Take note of the following warnings:

Warning

Statement 60 UL- and CSA-Certified Equipment Warning

This card is intended to be installed in UL- and CSA-certified equipment in the field by the user in the

manufacturer's defined operator access area. Check the equipment manufacturer to verify/confirm that your

equipment is suitable for user-installed application cards.

Warning

Statement 1030 Equipment Installation

Only trained and qualified personnel should be allowed to install, replace, or service this equipment.

Warning

Statement 1040 Product Disposal

Ultimate disposal of this product should be handled according to all national laws and regulations.

Warning

Statement 1073 No User-Serviceable Parts

No serviceable parts inside. To avoid risk of electric shock, do not open.

Warning

Statement 1077 Do Not Operate Unit Without Covers

The covers are an integral part of the safety design of the product. Do not operate the unit without the covers

installed.

You can remove and replace fan modules while the system is running. The air flow moves from front to back.

If you remove a fan or a fan fails, the other fans operate at full speed, which can be noisy.

Maintenance and Upgrade

4

FXOS Configuration Guide

Maintenance and Upgrade

to connect to the network module and make sure