Handoff A Mobile Station To A New Voice Channel; Release A Mobile Station - HP 8920A User Manual
Rf communications test set
Hide thumbs
Also See for 8920A:
- Application handbook (322 pages) ,
- Application handbook (319 pages) ,
- Programmer's manual (607 pages)
Table of Contents
Handoff a Mobile Station to a New Voice Channel
Release A Mobile Station
Using the CALL CONTROL Screen to Test Call Processing Functions
1. Ensure that the Test Set is in the connect state.
145
for information on how to bring a mobile station up on a voice channel.
2. If the CALL CONTROL screen is not displayed, select CALL CNTL from the To
Screen menu. The CALL CONTROL screen will be displayed.
3. Position the cursor on the Display field and select Data.
4. Select the Chan: field. Enter a new, valid voice channel number.
5. Select the Ch Loc: field (NAMPS system type only). Enter a new, valid channel
location from the Choices: menu.
Select the Pwr Lvl: field. Enter a new, valid mobile station power level.
6. Select the DSAT: field (NAMPS system type only). Enter a new, valid DSAT from the
Choices: menu.
Select the SAT: field. Enter a new, valid SAT frequency.
7. Select the Handoff field. The Access annunciator will light while the Test Set
signals the mobile station with the handoff information. If the mobile responds
properly, it will stop transmitting on the current voice channel, switch to the new voice
channel, and transpond the newly assigned SAT frequency. When the Test Set detects
this has happened the Connect annunciator is lit indicating that the handoff was
successful. The Voice Channel Assignment section will be updated; that is, any
"−" in the left-hand fields will be replaced with appropriate information.
Ensure that the Test Set is in the connected state.
145
for information on how to bring a mobile station up on a voice channel.
1. If the CALL CONTROL screen is not displayed, select CALL CNTL from the To
Screen menu. The CALL CONTROL screen will be displayed.
2. Select the Release field. The Test Set will signal the mobile station with a release
order. The mobile station will respond to the release order and cease transmission. The
Test Set will terminate transmission on the forward voice channel, and the Connect
annunciator will turn off. The Test Set will then reconfigure itself for transmission on
the forward control channel, begin to transmit system parameter overhead messages,
and the Active annunciator will light.
Chapter 6, Call Processing Subsystem
See "Page a Mobile Station" on page
See "Page a Mobile Station" on page
147
- Quick Links:
- Table of Contents
Hide quick links:
Table of Contents
