Quick Links
eZtrend GR and X Series QXe recorders -
Installation Instruction
Expansion Board
QXe Recorder
This Installation Instruction sheet is intended as a guide for replacing or installing hardware and for setting up
functionality in the recorder. Refer to the User manual for detailed operational requirements.
The eZtrend Gr and QXe recorders are designed for ease of assembly with minimal disturbance to the rest of the unit. If
unsure, please return the unit to your supplier for repair or upgrade.
Removing the case and opening the back of the recorder should only be performed under the following circumstances:
When an item of hardware requires individual replacement.
When an item of hardware is to be retrospectively fitted.
In all other instances it is recommended that the complete unit be returned to an authorised agent or service centre.
For Agency Approved recorders the product needs to be upgraded or repaired by an Authorized Repair facility
WARNING
HAZARDOUS VOLTAGES
Disconnect all power to the recorder before removing the case and attempting any maintenance procedures.
SAFETY TESTS
Upon completion of service procedures detailed in this manual two basic safety tests should be performed in order to
ensure continued safe operation of the instrument.
Earth Resistance; 25 VDC applied between case and protective earth, bonding resistance should be < 0.1 Ohm.
Insulation Resistance; 500Vdc applied between the earth terminal, and the live and neutral terminal shorted together,
insulation resistance to be >2.0 MOhm. (Mega Ohm, NOT milli Ohm)
Failure to comply with these instructions could result in death or serious injury
CAUTION
OBSERVE ANTI-STATIC PRECAUTIONS
Refer to BS EN61340-5-1: 2001. Basic specification. Protection of electrostatic sensitive devices.
Full anti-static precautions MUST be observed when in contact with the electronics of your recorder.
SAVE DATA, SETUPS AND LAYOUTS
Removal of PCBs and battery back-up will result in the loss of all non-volatile data.
Ensure all data and set-ups are saved.
Failure to comply with these instructions may result in product damage.
43-TV-33-81 iss.2 GLO Aug 19 UK
eZtrend Recorder
.
1
Related Manuals for Honeywell eZtrend GR Series
Summary of Contents for Honeywell eZtrend GR Series
- Page 1 eZtrend GR and X Series QXe recorders - Installation Instruction Expansion Board QXe Recorder eZtrend Recorder This Installation Instruction sheet is intended as a guide for replacing or installing hardware and for setting up functionality in the recorder. Refer to the User manual for detailed operational requirements. The eZtrend Gr and QXe recorders are designed for ease of assembly with minimal disturbance to the rest of the unit.
- Page 2 Before attempting to repair or upgrade a recorder, it is advisable to clear a sufficient work space so components such as the front panel can be rested on the work surface without getting scratched or damaged. Panel Mounting To replace or fit the Expansion Board the recorder must be removed from the panel. To require the recorder from the panel, loosen the mounting clamp screws, slide the clamp towards the rear of the recorder and remove the clamps and the recorder.
- Page 3 Removal and re-fitting the Expansion Board If the recorder already has an expansion board fitted, loosen the screws that hold all the I/O boards into the case. Pull each of these cards towards the rear of the recorder so that their connectors disengage from the Expansion Board. (The Expansion board stands vertically inside the recorder).
- Page 4 Inserting a Expansion Board Inserting a new or replacement Expansion Board is simply the reverse operation. Drop the new Expansion Board into the board guides and push it down until it is fully plugged into the processor board. Carefully slide all the boards back into the recorder ensuring that the connectors mate correctly with the Expansion Board.